Find a professional downpipe contractor in QLD

Clean gutter install downpipe and gutter guard. Install gutter to lean-to 5.1 m and downpipe, remove and replace 2 x2.7 polycarbonate roof sheet to corrugated zinc. Cover small hole to prevent vermin entry

I have 8 x colorbond rectangular style down pipes to replace as current ones are rusting, please note I don't know the cost hence the low amount

Connect new round downpipes. Supply own materials in quote . Need adapters from rectangle to round

need a plumber to replace a down pipe. the red line is what is needed to be done.

Had house painted down pipe removed it was damaged need replacement White pvc

Caport downpipes need to be relocated to connect with existing storm water pipe

Replace 1 downpipes guttering system

Looking for a licensed and experienced plumber to quote and complete the following work at our home. We would like to replace taps and spouts on: • 2 x bathroom basins • 1 x bathtub • 1 x shower • 1 x kitchen sink (single mixer) We already have all new taps and fittings ready to install. Additionally, some of the braided flexible hoses under the basins are rusty and need replacing. Please include supply and installation of new braided lines in your quote. We also have a broken downpipe at the front of the house that needs repair or replacement. Please include this in your quote as well. As I am working during the day, I am unable to take phone calls. Please send your rough price estimate by message only before confirming the job. Only qualified professional plumbers please.

Ive an existing house needing some new colorbond downpipes installed will remove old ones so just need new ones installed.

Gutter replace and add extra down pipes

Replacing guttering and pipe downpipe

Downpipe is broken needs replacing and guttering is leaking. Send photos through and measurements.

Upsize existing gutter outlet from 90 mm to 100 mm Supply and install new 100 mm downpipe Create a small offset below the eave so the downpipe runs straight and aligns with existing stormwater Neat connection into existing 100 mm stormwater line (current joins to be tidied/replaced) Secure downpipe to wall with brackets and seal appropriately Single-storey house. Access clear and trench already exposed (~1 m). Licensed roof plumber only.

We need to clean down pipe and also install overflow drain for box gutter for better flow during heavy rain. We have tried using drain snake to clear the down pipe.

Replace section of downpipe - elbow to join vertical section….no painting required…

I have a small section of down pipe that’s rusted out and needs replacing on the second storey of my house. Doesn’t need to be colour matched. Just want it repaired so the water stops dripping down onto the shed roof. The section is only about 50-70cm. Can send photos

Recent windy storms dislodged the join in a downpipe on my highset home. I would like it repositioned and reattached permanently. It is on a front corner of the house with easy access.

I need the pipe that’s feeding rainwater into our water tank to be diverted to pipe running out to street. Must be a qualified plumber have all tools and supply materials. Refer to photo / video. Should be a very straight forward easy job. Only an extra 4m or so of pipe required. Just want the job done properly.

Looking for a qualified plumber to complete two small plumbing/drainage repairs at a residential property in Margate. Both are above-ground PVC pipes and easily accessible — no digging required. --- 1️⃣ Garage downpipe – rear corner of garage PVC downpipe joint at the top elbow/horizontal section is leaking and showing mould. Likely cause: poor seal or misalignment at the elbow joint. Task: Inspect the joint and reseal or replace fittings as needed. Check that the short horizontal run has adequate fall for drainage. Ensure water discharges cleanly away from the garage wall/slab. Access: from ground level, right-hand rear corner of garage (see attached photo). --- 2️⃣ Under-house PVC drain (approx. 3 m run) Horizontal pipe under the house is installed flat with no fall. Task: Re-hang or re-support the pipe to achieve correct gradient (about 10–20 mm per metre). Supply new brackets/hangers as required. Confirm clear flow by running water through the pipe before completion. Good crawl-space access available.

need a handyman to reconnect gutter downpipe back to the storm water beneath the first flush