146 Door installers in Melbourne

Hi, I require either a carpenter, door installer, or locksmith to make an alteration to allow a latch to fit inside the strike hole again. The lock itself appears to work in that the key locks and unlocks the handle and latch of the lock, but the gate door won't ever lock. Looking closely, the latch doesn't sit inside the hole anymore and hits above it, due to a misalingment. When it was installed a couple years ago, it was working fine, however the door may have recenty shifted or warped, causing this, although I'm not sure. I am seeking someone to correct this, ideally by first checking the hinges and alingment of the door, etc. If this doesn't work, then perhaps remounting the strike plate higher or trimming off a bit of the metal at the top of the strke hole, or whatever you suggest. Best Regards, Mike

I have the door handle and hinges Don’t have the door, need a new door sized 240cm by 72cm You will also need to cut a hole for the door handle and latch

Need lock installed to new door. I have the previous lock. Or can purchase new. Just need it installed

Install a microchip doggy door

I need a dog door installed into a glass window or window pain replaced with Perspex/plastic sheet or safety glass.

Door handle snapped off. Need to remove, supply and install a new door handle. No specific requirements. Doesn’t need to lock. It’s a meeting room door.

Lost old key, need lock replaced on this door. Open to recommendations on if we replace handle. Please advise if quote includes lock supply, alternatively I can order the parts beforehand. Complete before end of June please.

Install gal lintel to replace metal door jamb.

Install door handle and privacy lock to outdoor toilet. Door is installed and needs to be buzzed a little on top left side.

Install smart door handle into door

The left door motor is not functioning for the central lock system, probably need replacing. Toyota Corolla 2005

I have a new door handle that needs to be installed however the holes from the existing handle do not line up. I need someone to install the handle and most likely drill either new holes or widen the existing main hole. I don’t have the drill to do so, you will need your own. Should take all of 20 mins and happy to work out a csh payment

Install a door handle & locking mechanism for a bathroom door. The door & frame is brand new with no handle or lock holes pre drilled, however it has been hung. Hardware has been purchased and is ready to be installed. Ideally you can complete this task on Wednesday this week

We are converting a store room into a small office. We need the shelving removed (and disposed of), the room painted, and the door replaced.

Hi, I need someone to help me install these noise seals to 3 office room doors located on St Kilda Rd, Melbourne VIC 3004. You will need to bring a saw to cut it to size and your own tools such as a drill.

Replace door casing / door architrave on one side of an internal door (bathroom)

Need door installed, sanded and painted + hole in wall fixed

Door hinge has dropped preventing door closing. Appears to be metal hinge in metal frame (ie no visible screws to tighten). Will likely need replacing. Need fixed ASAP as preventing us using room in business.

Emergency replacement of back door into house after break in last night

I need: 1. A door handle changed over to a new one. The new handle will be supplied (pictured) and just requires two holes to be drilled in the correct place. 2. Two small door stops installed on the skirting board for internal doors (these will be supplied and just require a single hole to be drilled in the correct place). 3. Two clothes racks (will be supplied, see picture) to be mounted on a bathroom plaster wall (not tiles). I want to make sure this is done securely, i.e. to the studs, or whatever is the best way to do this. I also have a number of other jobs/carpentry items that I would like some advice/to be quoted on separately, like installing some shelving in a cupboard, putting a trim on some external windows and mounting some other items on the walls. The job is in CBD Melbourne. Happy to adjust the price if additional tools or time are required, as I want to make sure everything is done well.