Find experienced local carpenters in Gold Coast

This is an Easy Shed partnered with Airtasker , shed is delivered and ready for assembly , concrete area is prepared and ready. easy access at front of property in courtyard.

Help build up new internal walls Please offer how much per hour

Looking to get this custom built shelf as seen in the picture.

We need a metal pole cut and put into our wardrobe (we have the materials)

Need inner wardrobes fitted, 3 wardrobes that require a top shelf and hanging bar and 1 that needs multiple shelves for a linen cupboard Measurements linen cupboard H- 2400 L- 1800 W - 500 Master bedroom L 1560 W 500 Bedroom 2 L1516 W - 500 Bedroom 3 L - 1680 W - 500

I have two shaker style bathroom vanities sitting side-by-side and as the tiler didn’t tile to the edge of the room, I require a solution that joins both vanities together seamlessly and covers that exposed floor space. I would like a small platform built to cover that gap and a face panel at the front. I have two shelves in the same wood and paint colour as the cabinet that can be used for the job. I’d like a raised piece at the same height & style as the first 10cm rise on the existing vanity and a shaker style face panel between the two vanities stepped back slightly, but joining the vanities together to make them look like one long vanity instead of two separate vanities. The gap between vanities is approximately 22.5cm as can be seen in attached photos.

Looking for an experienced handyman to help me fit a half donzen Lux veneer panels to the walls to our office. The panels need to be installed with precision and care to ensure a seamless. Couple of power points need to be cut around., high-quality finish. The office space is approximately . Previous experience with veneer panels preferred. Please bring your own tools. Quick turnaround required. I’ve already had the panels cut to length. How ever some panels might need just need to be trimmed down ever so slightly. Would preferably like to do today or tomorrow

The pad should be 3m by 4m and 100mm deep with rebar layer. Pad also needs a rebated lip round the edge for the colorbond to sit over. The site has a slight slope but good access with a double gate, please provide offer for full job including labour, concrete and all materials.

4 wooden boards need to replaced on back deck

Looking for a person who can confirm the measurements for the laminate bench top to be ordered and installed in our kitchen. This person needs to be 100% of the final measurements as we will be ordering from the factory and also be this person to install the bench top which it will be ready in the next 2 weeks. Please note we are paying more for the installation. We need first someone to confirm

hinges have come off the bottom of a small platform. It needs a small piece of wood attached and then the hinges re-done. Should be very simple. Maybe 15mins work, plus a trip to Bunnings if you needs screws an a small piece of wood.

I am searching for someone who is able to remove smudged candle soot of the corner of a bedroom & ceiling wall. Not sure what’s required but has been a struggle to remove myself and resulted in a bigger area of stain needing removal before Monday morning.

I’m looking to replace the old kitchen benchtops with new laminate benchtops. The person who was going to install them has run out of time to do this job and can no longer do it. Pick up pre cut from Burleigh and install. The sink hole needs to be cut out

There are a few moving parts to this. Essentially I am after a Handyman or chippie that can extend this leantoo to go to the end of the shed. I will supply all materials. You are welcome to use some or all of my tools also, however best you use your own (as most prefer) I have Auger to do holes if this isnt in your arsenal. The right person has experience with doing this simple kind of leantoo structure and working with Sheds. (top hat, Zinc etc) My son or I are available on site to assist with bits that need 2 people. This would likely end up being a week or so work for the right person. Work may not be in consecutive days, and whilst I am flexible to some extent, I am needing to get the tasks done that I need in the coming 2 or 3 weeks. Rate offered is first day work. thankyou.

We have had a new roof put on, and need to put up the new soffit sheets. On one side of the house and the back, The “side” still has all the framing so it should be just nailing up the new sheets. The back will need a small amount of framing and then the sheets. Photos attached, I am happy to provide the sheets,framing, clouts etc. Or you can provide a cost for materials also.

Installation of -two! - 6.0x 4.0 meter, 4 tier new grandstands installed. Will require minumum two people if you think you need more its up to you ( they also say 4 sometimes). comes with instructions . concrete base already in place price for two stands please and prefer if experienced with this sort of assembly or similar. Delivery Monday 3rd before 9am. be goof to Start that day if possible . Broadbeach area

Hi I have a bookshelf that needs to be built but also turn the bottom cabinet into a lockable cabinet.

Sand deck /pizza oven and ultra deck natural 2 coats 66 m2 deck and pizza oven

Need someone with a circular saw to cut a piece of Specrite timber from Bunnings. Cut the piece from 180cm to 160cm. To be used as a desktop. I will bring the timber to your place/workshop to cut as I live in an apartment so can’t do here and I don’t own a circular saw. Would need you to be within 30 mins drive from Southport. Thanks

I have a set of built in cupboards. There are 3 doors I need to have locks fitted to so the cabinet can be locked. Doors are timber. Ideally all keyed alike