Find experienced local carpenters in Coomera

Looking for an experienced person to clean, prepare and restain an outdoor timber deck at a waterfront property in Coomera Waters, Gold Coast. The deck includes: * Large open entertaining deck overlooking the water * Covered outdoor BBQ and dining area * Timber stairs and smaller connecting deck areas * Exposed timber edges and fascia boards Scope of work: * Thoroughly clean and prepare existing decking * Light sanding where required * Apply suitable exterior decking stain/oil (preferably two coats, depending on product) * Protect glass balustrades, aluminium railings, walls and outdoor furniture * Leave the area clean and tidy upon completion Photos attached showing the areas requiring attention. Looking for someone with previous deck restoration and staining experience who can recommend the appropriate preparation and finish. Please provide a quote for labour and materials, or advise if materials need to be supplied separately. Flexible with timing for the right person.

Cabinet needs to trimmed to suit Under mount so will need a board to trim out and face to cover range hood when doors open

Have timber skirting around door that needs replacing.

I need some panels cut to pass on the upholster for vinyl walls installation. I will also needs some couch alterations to make a kidney shape on a rectangular base

Dishwasher installation – cut an opening in the cabinet to allow the pipes to pass through.

Repairs to wall and skirting boards following installation of barn door.

Need roof trusses modified. Here is a description of what needs to be done: The bottom chord of the truss (ceiling joist) is a 90x45, this chord will be strengthened using a 140x45 MGP10 beam added spanning 3.0 m. The beam is screwed to the ceiling joists every 600 mm. The top chord of the truss (roof rafter) is a 90x45, this chord will be strengthened using a 140x45 MGP10 beam spanning 3.0 m. The vertical chords can then be removed. The unit is safe to be suspended to any of the trusses, modified and nonmodified. The same method is to be used for the three trusses. A maximum of 3 trusses to be modified I don’t have the materials so I will require those.

I have an engineer drawing up the plans for this at the moment. But it will essentially be cutting the marked trusses (3) and reinforcing them with plates to make room for a ducted AC unit

Carpenter - install flashings above window, seal gap in top corner of cladding, fix sarking on bottom of the window. Drywall has been removed.

I have an AEG Fully integrated Dishwasher that has a loose door panel. Some of the screws have loosened. Have attached pictures

Sand back door and frame and re-stain. Just the outside as it appears to have been affected from the sun.

I have a 63 Manhattan berthed at Sanctuary Cove Marina. There is cream carpet in the hallway and bedrooms. A leak resulted in a dark stain on the carpet in the hallway and I need to have this cleaned professionally. I also need to have the couch in the main bedroom cleaned & the carpet in that room too.

A cabinet to be made across a refrigerator Top of cupboards to be filled in Two shelfs to be made above splashback plus a Backing for island cupboard

Hard to describe but I’ll try. We have a raised house that has wooden slats at the top of the decking (photo shows the wood slats in white about the carport). We have a brand new decking that needs the same slats but in merbau to continue the style. We have other carpentry work, but the slats are urgent as photos being taken Friday to go up for sale.

The bottom plate/timber base is rotted and compromised on small section of property. It’s no longer providing a proper barrier or structural support, so it needs to be replaced or repaired to prevent moisture ingress and pest entry

Construction site. Carpenter needed for carpentry work. Best come to site and chat. Thanks

3m x 3m sheds. Total area 6m x3m. Two. Flat site with 4, corner concrete supports in place. Place side by side. On raised wooden flooring.

Paint over cup stain with matched paint, if you can do it cheaper than our previous RE that would be great.

Need my deck retained to same colour when it's not raining. Approx 3 x 5mtrs

Need someone that can remove 3 screws that are stuck, not sure if there stripped. Also need someone that has an angle grinder that can cut thru small nails that holds aluminium sheet on to get to the screws in the cabinet to dissemble it.