Find a reliable cooktop installation and repair service in Melbourne

60cm gas cooktop replace and remove old gas cooktop 4 burner same size.

Need an electrician to remove my induction cooktop and install the new one that I have

Hi I require a registered sparky to put in a new oven and cook too please. My tenant moves out on 2/2 and the new one moves in 5/5 but flexible on time. I’ll await your quotes. Only reasonable quotes will be considered.

Measure electric cooktop and install a new one.

Description: Looking for a licensed electrician (VIC) to inspect, quote and replace a smashed IKEA 4-zone induction cooktop Existing unit: • IKEA MATMÄSSIG induction hob 300 series, black (AP) • Like-for-like replacement preferred (or compatible equivalent) Scope: • Site visit + quote • Supply and/or install replacement cooktop • Remove and dispose of damaged unit • Install, test and confirm electrical safety/compliance Timing: • Quote/inspection: Thu 15 or Fri 16 • Installation: Tue 20 or Fri 23 Please include licence details, availability, estimated cost, and whether you can source the cooktop.

Remove old gas cooktop, install new gas cooktop and give a gas certificate

Replace gas cooktop with a new one

Hi need help.installong electric induction cooktop.fix power switch in kitchen

Install kitchen appliances in an apartment.

Licensed plumber required for the installation of new gas cooktop. 600mm 4 burner. Gas to unit is off, existing lines as pictured. New unit product code- the hood guys: GGSCG6004. Compliance certificate required upon completion.

Need to replace gas cooktop (like for like, new one provided). Location is Melbourne. CBD. Photos provided. Timing is flexible, even evening is fine. Prefer to avoid early morning if possible.

Cooktop induction installation - wiring is set, the cooktop needs to be connected and dropped into slot. Should be 20 minutes at the most.

Hello! Just needing an old 2 burner cooktop swapped out. We have the new one already, just need someone to remove the old and install the new.

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – in my apartment located in Melbourne CBD. • New cooktop is already onsite and already fitted in.

I need a handyman / stone benchtop specialist to slightly enlarge an existing granite benchtop cut-out so a new cooktop fits correctly. The cooktop is already on site but does not sit flush — the cut-out is a few millimetres undersized / out of square. Job is located in city ( on La Trobe St) There is off street car park

• The existing electric cooktop is faulty and needs to be removed and replaced. • I haven’t bought the new cooktop yet. • You can buy this electric cooktop from Bunnings and I’ll reimburse the full cost: https://www.bunnings.com.au/bellini-60cm-4-burner-electric-cooktop_p5102272 It’s the same size, same cut out So pretty much straightforward

Need an over and cook top (single unit) disconnected from the gas.

Needing a two plate standard cooktop exchanged please (old one is scratched but working). Have a new cooktop ready - two plate of the same size. See photo of the cooktop purchased from Kogan. Just need it exchanged over. Existing cooktop is working still and no underlying cabling problems. This is a well maintained and new apartment complex. Please show us your electrical license. Thank you.

Here is the photos of kitchen, have separate line for oven and rangehood already. need to finish up circuit connection for induction cooktop(see photos for progress). Please note you will need to supply cooktop safety switch that can be integrated into existing power point seamlessly without needing extra holes for seamless look - refer to photos for placement. New appliance are Bosch- here are serial numbers for reference if needed Oven: Bosch – HBG976MB1A - line exists Cooktop: Bosch – PVS631HC1E - finish line connection(pre drilled holes) Rangehood: Bosch – DBB67AM60A - line exists Also will need LED lights installed in cabinets(have two of them for each side of range hood) to be connected to the power point on top. Have LED channel as well)

The cooktop is a 4 burner Smeg - only one is not sparking and cannot be used. The task is for the repair of the defective burner. Flexible with the time and date but I need it done sooner than later. Melbourne CBD close to Queen Victoria Market.