Find experienced local carpenters in Rivervale

Need wardrobe door tops gently planed and then capped with pine timber stripping( doors were cut lower and exposing internal stuff ). Doors also need extra hinge added to top of both doors (needs wood router for the hinge hole), as they are a bit loose. Need an MDF panel (1440mm W x 535mm H x 16mm D) mounted and securely screwed above wardrobe doors. This is painted and ready to go up. Must be today due to a deadline. Must be an experienced handyman/ cabinetmaker/carpenter who is qualified, punctual, professional and efficient. Most of the work has been done so it's just touching up work on the doors and help securing the panel mounted and screwed into the timber, as it needs to hold an aircon unit 15kg. I have a small work bench and clamps on-site. What you need to supply: 2 wardrobe cupboard hinges, a planer, a wood router, timber stripping 25mm wide x 713mm long per door, and wood glue. Timber screws that can either be drilled through the mdf into the timber frame, or used in 90 degree angle brackets. If you are organised and efficient estimated work time: 90-120min max.

Replace 2 white cabinet doors as water damaged. We are the plumbers who got them wet. They are bunnings cabinet , flat pack style doors. Should be easy job

Tile space, trim side ledge to make it even. Seal ledge and add a bathroom vanity in space - Due date: Flexible

I'll be removing the old kitchen cabinets and appliances. Want similar layout with new cabinets for new benchtops, sink and appliances.

Have Metod wall cabinet from ikea. Cabinet is already put together the railing just needs to be attached to wall and the cabinet then hooks onto railing The railing will need to be cut as it’s 2m long and the cabinet is only 80cm wide

Moved in to a place with one floating cabinet. Would like to get 4 cabinet doors replaced with solid (opaque) soft-close cabinet doors that sit correctly and match cabinet. Task: source cabinet doors and install doors that match/fit with cabinet. I would source door handles. Measurements (approx): 505 x 425mm per door Completion date: flexible as sourcing doors may take time. Will have future cabinetry work also.

I need someone to remove 2 water stain from carpet and few other small marks. Preferably with a machine for it.

I put a fuel can down on the tiles for a few weeks and the bottom of the can created a ring of rust on the tile belolw it. I need this cleaned . It is resistant to CLR and scrubbing so might need professional help. Tile below must not be damaged. Need this done Today 14th Dec. Thanks - Due date: Needs to be done on Tuesday, 14th Dec 2021

Need experienced person to sand back and stain 2 coats of exposed side of sliding stacked door. Sanding needs to be to bare wood as it has weathered differently in parts. Will provide orbital sander and stain. Date is flexible. Needs to be completed during good weather with a few sunny days after to dry.

Need kitchen cabinet renovation, touch up to make it look decent . change top bench...

Finish installing laundry cabinets. Base cabinets are built. Just Need side panels attached, bench top, doors ect installed and kickboard cut to size. Will also need two holes cut into bench top for washing machine pipes.

1. A shoe rack with about 3 or 4 racks 880 long x 500 deep x 1000mm high.there is an existing clothes rack currently there so there are timber’s on either side inside the walk in robe. 2. Set of 3 draws same dimensions and again this is in the walk-in robe with timber’s on either side. Both are clothes hanger bays but I’d like a shoe rack and drawers. 3. A built in computer table top with a under slide out key board shelf. 1100 mm long x 540mm. Panels on both sides of this exist as it’s a clothes robe at moment. All is in white board