Find experienced local carpenters in Belmont WA

Have 2 wooden jarrah high quality chairs, the wood is splitting need a competent carpenter to re glue timber together. Note the photos taken are from the worst chair and on one side. The second chair is only 1/2 the splitting of wood. I dont have enough clamps to fix myself.

Need to cut some timber bits accordingly

Relocate and adjust cabinets to allow for the installation of an existing dishwasher. 1. Relocate drawers to beneath stovetop (Red in Image) 2. Create small fill panel (or cupboard if feasible) 3. Install Dishwasher in Blue area (Beko BDF1410W) 4. Additional Water offtake for Dishwasher required (tap into existing water supply under sink) 5. Reduce size of cupboards (Green) Power outlet close by in corner cupboard (in cabinet under microwave). Have confirmed the drawers depth will git with existing gas supply under stove. Installation to utilise existing cabinets to ensure seamless installation. Dishwasher is not built in, so standard installation required. Can send more images if required.

Need new laundry door with white gloss. Will need cabinet maker for this. Supply and install

Hi there, I have a stainless steel tray used for a pizza oven and require 2 s.s handles to be welded on each side.

Install Ikea Metod Wall Cabinet Items will be purchased Wall cabinet frame, white, 80x37x100 cm Ikea Wall 1 - 4 to be installed Wall 2 - 3 to be installed

I have a dishwasher that I want to install and need the kitchen cabinets removed and altered to fit around it.

Replace the rotted wooden barge board (whatever it is called!) with appropriate material and install. About 1.5m - Due date: Flexible

I have pre assembled kitchen cabinet. To be installed onto my kitchen wall. A 3 door cabinet and 1 door to be installed next to each over. No need to assemble - Due date: Flexible

Need to add some storage in my kitchen ( cabinets) - Due date: Flexible

We have a race car transporter currently being finished off for our race team this coming Speedway Season. At one end of the truck Pantech, we have a small room up front (Dimensions: 2,265mm long - 1,950mm wide - 2,200mm high). I guess in total I’m looking at the following: • 2 x overhead cupboards (1,500mm long x 400mm high x 300mm deep) – (these are denoted in ‘blue’ below) • 2 x lounges with two roller drawers – (1,500mm long x 950mm high x 650mm deep) – (these are denoted by the ‘maroon’ below) • 1 x upright cupboard/shelves unit (765mm long x 2,200mm high x 650mm deep) – this has two cupboards at the bottom, then two roller drawers, a space to work on, then shelf above) – (in ‘red’) Would need to be built off site and then put into position for fixing (note: I only have a 600mm x 2,200mm access door to pass these through for final install – so partial assembly may be required). - Due date: Before Saturday, 11 November 2023

A)To put a strip of wood to bottom bit of cupbpard B)to cover a dent about 1 square foot inside cupboard C) to put 2 cupnoard doors back. - Due date: Flexible

Name your price! Need to change the cabinet so it will fit a dishwasher. Currently the cavity is 56cm wide, if sides of the cabinet/whole taken out it will give 60cm which is perfect to fit a dishwasher. The countertop is sitting on cabinets I’m assuming so some sort of solution has to be found. Please see photos attached. - Due date: Flexible

Wooden ledge needs to be sanded and stained polished to make it look new. This is similar to a bar table but outside. Photos attached. - Due date: Flexible

Need to have some oil and other stains removed from the double (home) carport plus remove a small patch of oil on the driveway in front of the carport. - Due date: Needs to be done on Thursday, 5 May 2022

Looking for sombody to renovat the kitchen

Looking for a carpenter for a minor job in restaurant, located in Belmont