Find skilled builders near you

Looking for an experienced installer to assemble and install an EasyShed flat pack on an existing concrete slab. Job details: - Shed size: 2.25m (W) x 3m (D) x 2.4m (H) - Type: EasyShed gable roof, clip-on system - Scope: Full end-to-end installation (Unpack flat pack, Assemble all panels and frame, Secure shed to concrete slab using 2 packs of concrete fixings (provided)) Requirements: Must have prior experience installing garden sheds (EasyShed or similar) Bring all necessary tools and equipment Ensure proper alignment, leveling, and secure anchoring Product Preference - https://easyshed.com.au/products/2-25m-x-3m-gable-roof-garden-shed?variant=46656307691679

Need a handyman/ex-builder who can initially consult and then eventually execute converting a pergola into a proper living space. Obviously this is just the consultation cost but only need people who can actually organise/ do the job. This is a pergola I’m the hills it’s currently decked and raised from the ground using pillars and metal fixtures underneath.

Need to remove a garbage from back yard. Will need an onsite quote.

I bought a shed online . I’ve got it delivered and need to put it up .

I am looking for a shed installer to install an Easyshed 3.75m x 4.5m Garage Shed on concrete slab. See photo of the shed attached.

Need to fix the leakage between the joint of pergola and house wall. And one another hole in the pergola roofing.

We renovated our drive way with Aggregare Exposed concrete and the concrete was poured in two stages, concrete was poured on the first half and second half on seperate days, when washing was done one half came good the top layer cement was washed perfectly exposing the stone chips, but the second half didn't turn out properly as the top layer got hard before pressure washing, advise needed for fixing this.

Need my driveway repainted. I believe they used Berger jet dry previously. Not sure exactly on colour. A sealer needs to be added after it drys

Rebooking task between Casey and Aaron

Demolition labourer for tomorrow, just demolishing balcony with team of boys, need someone with experience

The soil is a mix of good and clay with a few bricks, a few small roots. Good for landfill. You will need a excavator to remove it.

I'm getting 3 cubic metres of sandy loam dumped in my driveway. I need to move it and spread it over my sodden backyard lawn. I have a wheelbarrow and trolley and tools/spades. I need someone fitter than me to help me get it done. Would like it done this weekend so I get my driveway back.

Assemble 2 ABSCO Sheds on existing concrete - 1. Absco Sheds 3.0 x 1.52 x 2.08m https://www.bunnings.com.au/absco-sheds-3-0-x-1-52-x-2-08m-monument-space-saver-double-door-garden-shed_p0079540 2. Absco Sheds 3.0 x 3.0 x 2.06m. NOTE : Individual sheets - Roof, 2 Side and Rear is already assembled. Front (with Door) sheet to be done before final assembly of shed. https://www.bunnings.com.au/absco-sheds-3-0-x-3-0-x-2-06m-monument-premier-double-door-garden-shed_p0084389

Assemble EasyShed gable roof garden shed (2.3m x 2.3m) on existing concrete slab. Shed kit is on site and ready for assembly. Installer to provide own tools and anchor shed to slab. Previous experience with EasyShed or similar steel garden sheds preferred. Located in Eagleby.

Help load up skip and demolish some decking / framing. 7 hours

Looking for someone handy to jack up the corner end of my pergola and screw it back into the existing bracket but slightly higher. The gutter wasn’t draining so I thought I could do it myself, I got one bolt out and it dropped so I can’t get the other one out and it’s way heavier than I expected.

We have the paint and rollers and tape, but we can't do it, the surface has been prepared and is ready to go, it needs two coats with a two-hour drying time in-between coats the driveway

Partially completed Easyshed 6m x 3m workshop assembly A dishonest person took half the money and partially completed the shed, and then disappeared and blocked my number. Whoever takes this up will be picking up where he left off.

I am looking for someone with experience in earthworks and access to suitable machinery to help prepare access to my home-based dog grooming salon. The property currently has a steep, muddy slope with no existing pathway. The job includes: Excavating and levelling a pathway from the driveway to the salon entrance Levelling and improving sections of the driveway Creating a safe and practical access route for customers and their dogs Cutting out and preparing the pathway area for weed mat and rock installation (weed mat and rocks will be supplied and installed separately) General site tidy-up of disturbed areas The property is located in Cockatoo, VIC. Please let me know: What machinery you will use I have included a photo of the pathway I am after. I will need the wood beams installed but not the gravel. Photos can be provided, and site inspections are welcome before quoting. Completion before 12 June highly preferred as access is required for a home-based business opening

Need these 2 driveway ramps drilled screwed into the ground. 4-6 screws each. So it stays put