Find a professional blueboard contractor in NSW

I have a shed that needs remodelling as I’m turning into a hair studios. It’s made from aluminium so the inside just needs to be boarded up and the ceiling needs to be gyprocked so that lighting can be put in. I may also need a window installed. The roof in the shed has some fibre board put in that’ll need to be removed before starting. It should take a days worth of labour. All materials will be supplied (you can let me know specifically what’s needed.) willing to pay a day rate of $500 cash.

Multi tasker handyman required. Require some plastering on crack (add support wood), trim on gyprock, some gap plaster, villaboard small amount on eaves, some trims around eaves, blueboard cut small piece and stick and screw more in one's in wall.already, pack out fron door wood, under door gap thing screw on, magnet stoppers x 2, small little things. Install man whole. Small little jobs around the house. I pay material may need pick up. Day rate only.

Repair this blue board with suitable external screws, push it back in n fix in place without break it.

Hey I have 4 poles at the front and I want to make them thicker . So I need 3 timbers place ( 1 and the front and 2 at the back ) and then I need blueboard installed

Need blue board installed 3 sheets i have materials very narrow on fence line might need panels taken off

Hang 5 blue board sheets add insulation cut sheets to size

Need to render the blue board. Need to be in the plastic render not cement

Install 2.4x 1.2 blue board sheets install insulation., reinstall bars Paint seal make good light grey

Installation of Blueboard, access panel below cistern, eaves/fascia & roof gutter

Job includes: - Rendering Blueboard / Villaboard under the roof line (requires acrylic render). - Brick patching and rendering below the sliding doors.

Remove and replace the Blueboard panel with new Blueboard panel 6.0mm thick .The size is 2.2 x 1.1 metres. The frame of gate is 40mm tube steel. The hex head screws have to match other gate panel positions that is beside it.( 2 SLIDING GATES ) Paint match inside (Backyard )Exterior ColourBond and match exterior Porters Limwash Terracotta .The second gate will have to be painted in Terracotta limewadh to match as it is faided from the sun . Rear lane access and parking at rear lane .

Replace three cement sheets with blueboards

Two parts to the job. Outside: Remove partially broken blueboard section. Replace with new blueboard section: approx. 2000mm x 900m. Waterproof entire section down to concrete floor/ brick footing underneath. Acrylic render new blueboard section to match existing. Inside: Replace broken villaboard section. Patch joints. Approx. 2200mm x 450mm. Como 2226 Must be licensed tradie with good blueboard and waterproof experience.

Seal joints and waterproofing of Blueboard cladding around a corner window

Repair shed with blue board sheets

Render blueboard so it is flush with the rest of the wall 3.8m(W) x .26m(H)

I need a hole patched in a blueboard fence. You will need to patch the hole and apply joint compound etc. I will paint it later.

To cover the pergola area with blue boards outside and gyprock inside.

I need to remove the pattern on the external wall and install blueboard in the marked areas

I have a 5x5 bbq cabana. I have all materials ready to go. Looking for someone to finished battening (90x45) then apply blue board in prep for render. Looking for a handyman/tradie for the day.