Hire a trusted gas stove repair and installation service in VIC

Need someone to remove the existing 50 cm cooktop and install a different one

Connect gas cooktop to gas outlet. Original copper line connection is too long, needs to be resized.

Install a gas isolation valve for gas cooktop

The gas cannot ignite. May also check if there is any gas leakage

remove and install rangehood and gas stove top provide gas certificate for gas stove top

Looking for gas plumber to connect cooktop. Location: Sunbury. Certificate required. We’ll only supply Bosch cooktop PPQ7A6B20A. Model: You would need to bring 900mm to 1000mm flexible gas hose, regulator (if required for this cooktop), isolation valve, elbows etc. Please see pictures.

Please quote for following: - replace existing gas cooktop with new induction cooktop - located on ground floor - switch board and cooktop location approx 10 metres apart - new induction cooktop Westinghouse 60cm 3 Zone Powerlite Induction Cooktop will be provided - leave gas cooktop on the premises - disconnect and cap off existing gas point. Need compliance certificate Job located in Laverton 3028 VIC.

Need gas fitter to temporarily disconnect gas stove before DIY kitchen renovation.

I have a gas cooktop where 3 out of 4 burners work perfectly. However, one specific burner is not sparking/igniting automatically. Note: If I use a manual BBQ lighter/match, the gas flows fine and the burner lights up safely, so the gas line is working. It seems to be just the individual ceramic igniter pin or wire for that specific burner that needs fixing or replacing. Looking for an experienced appliance repair technician to come diagnose and fix/replace the faulty igniter part.

Disconnect gas cooktop, last gas item in my place. Should be straightforward. No need to reconnect.

Renovation. Install new oven, secure existing power to wall. Add another PowerPoint for gas cooktop. Rangehood is connected.

Replace the existing gas cooktop with the new one.

Hi, I’m looking for a licensed gas fitter to inspect an already installed gas cooktop. Just need a quick check of gas connections, leaks, and overall safety/compliance, and a compliance sign-off if all is okay. If required, a gas isolation valve may need to be added underneath the cooktop. A cement sheet has been installed behind the tiled wall for heat protection due to slightly reduced clearance (around 125mm). Original installer is unavailable, so just after a routine safety check for peace of mind. Location: Melton west, 3337

Need to disconnect and block off gas stove. Also check for leaks while in there so it’s not left dodgy, but also shut off mains as gas is no longer needed. I’m getting the stove removed the following day hence the deadline. Can be any time on Tuesday from 9 until late. Other info: single story home, about 80 years old.

Hi, looking to get my 90cm Technika Gas cooktop replaced. I have already bought the cooktop. If you are available after 5pm today or tomorrow would be preferred. I am located in riverwalk Werribee Thanks

Need new 60cm cooktop to be installed. Gas pipe redirected behind plaster

Hi everyone, I am looking for a licensed plumber or gas fitter to permanently disconnect and cap the gas line to my broken cooktop so I can safely have an electric induction unit installed later. My current setup is a standard 60cm gas cooktop sitting directly above a Westinghouse electric wall oven. The gas is currently turned off at the main valve and the benchtop is laminate. I need you to safely disconnect the broken gas cooktop and permanently cap the gas pipe behind the oven. You will also need to test the line to ensure there are absolutely no leaks and issue a VBA Gas Compliance Certificate, which is mandatory for me to proceed with the electrical stage. Please leave the decommissioned cooktop sitting in the benchtop cutout once disconnected. My electrician will remove and dispose of it later to ensure dust and debris do not fall into the exposed oven casing in the meantime. You do not need to do any physical removal or electrical work. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week. Cheers, Sean

Looking for a licensed gas fitter to disconnect a gas cooktop and install a 1/2 inch gas cock to safely isolate the gas supply. Please provide a quote and availability, cheers!

Need someone who can replace my 900 Gas cooktop, please see the picture of old and new cooktop

Need to replace gas cooktop (like for like, new one provided-Westinghouse Model WHG644SC). Location is Melbourne CBD. Photos provided. Timing is flexible (other than Wed,Thursday and Friday day time), evening any day is fine though. Weekend is also ok. Prefer to also avoid very early morning.