Find a reliable cooktop installation and repair service in Melbourne

Cooktop induction installation - wiring is set, the cooktop needs to be connected and dropped into slot. Should be 20 minutes at the most.

Hello! Just needing an old 2 burner cooktop swapped out. We have the new one already, just need someone to remove the old and install the new.

My stovetop has a chip and crack.

Remove existing 60 cm cooktop, disconnect electrical/gas connections. Install new 60 cm cooktop, and reconnect

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – in my apartment located in Melbourne CBD. • New cooktop is already onsite and already fitted in.

I need a handyman / stone benchtop specialist to slightly enlarge an existing granite benchtop cut-out so a new cooktop fits correctly. The cooktop is already on site but does not sit flush — the cut-out is a few millimetres undersized / out of square. Job is located in city ( on La Trobe St) There is off street car park

Smeg gas stovetop / cooktop needs servicing - large burner flame runs too big. Apartment building. Price is just a placeholder - open to all fair offers and will pick the best offer with the best experience.

• The existing electric cooktop is faulty and needs to be removed and replaced. • I haven’t bought the new cooktop yet. • You can buy this electric cooktop from Bunnings and I’ll reimburse the full cost: https://www.bunnings.com.au/bellini-60cm-4-burner-electric-cooktop_p5102272 It’s the same size, same cut out So pretty much straightforward

The cooktop needs an urgent service and there is flame which needs expert to have alook and fix

Clicking ignitor of SMEG cooktop wont stop clicking - any oven technicians?

60cm gas cooktop replace and remove old gas cooktop 4 burner same size.

I purchased a new cooktop and when my electrician went to install it the cutout space in the stone bench top is just a tad too small - not by much… From memory Electrician said it was less than half a cm? Looking for someone to make the cutout bigger so my new 60cm cooktop fits

I'm upgrading from an electric to an induction cooktop and need help from an electrician to install it. The power is already isolated and on its own dedicated circuit. The new cooktop requires 26amps and the circuit is rated for 32amps. Cooktops are the same size and I've already removed the electric one.

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – WHG640SC in my apartment located in Melbourne CBD. Details: • Location: Melbourne CBD (easy access, lift available) • New cooktop is already onsite It needs to be done on 03 December late afternoon Thanks!

Remove Miele gas cooktop and replace with Smeg cooktop which is here and the same size

We need to remove and dispose the existing cooktop and oven; and, install the new ones. The new one's are the same size as the old ones.

Need an over and cook top (single unit) disconnected from the gas.

Needing a two plate standard cooktop exchanged please (old one is scratched but working). Have a new cooktop ready - two plate of the same size. See photo of the cooktop purchased from Kogan. Just need it exchanged over. Existing cooktop is working still and no underlying cabling problems. This is a well maintained and new apartment complex. Please show us your electrical license. Thank you.

Here is the photos of kitchen, have separate line for oven and rangehood already. need to finish up circuit connection for induction cooktop(see photos for progress). Please note you will need to supply cooktop safety switch that can be integrated into existing power point seamlessly without needing extra holes for seamless look - refer to photos for placement. New appliance are Bosch- here are serial numbers for reference if needed Oven: Bosch – HBG976MB1A - line exists Cooktop: Bosch – PVS631HC1E - finish line connection(pre drilled holes) Rangehood: Bosch – DBB67AM60A - line exists Also will need LED lights installed in cabinets(have two of them for each side of range hood) to be connected to the power point on top. Have LED channel as well)

The cooktop is a 4 burner Smeg - only one is not sparking and cannot be used. The task is for the repair of the defective burner. Flexible with the time and date but I need it done sooner than later. Melbourne CBD close to Queen Victoria Market.