Find professional window sash replacement services in London

Attach carbon monoxide alarm, mend broken sash cord, tighten dripping kitchen tap

replacement of the outer box, mouldings, facials and soffits (and maybe the guttering) of 1st floor sash window.

Repair sash window – fix or replace damaged sash cord One of my sash windows still opens and closes, but the left-hand sash cord is damaged or detached, and the counterweight inside the frame may be stuck. The tension feels uneven when opening or closing. The work should require: Remove the interior staff bead (thin strip of wood on the left side holding the lower sash in place) Take out the bottom sash carefully — lift it slightly, tilt it forward, and rest it down Open the access pocket on the side of the window frame (small painted-over panel about 10–15 cm tall, held by one or two screws) Retrieve the counterweight and attach a new sash cord (cotton or waxed nylon) Thread the new cord over the pulley wheel, reattach it to the sash, and rebalance both sides The window and glass are intact; it just needs the cord mechanism repaired and adjusted. Please bring the cord and tools.

I need someone to repair a wooden sash window where part of the frame/slide has rotted and is coming loose. Property is located in N7 Photos can be provided on request. Open to quotes depending on materials and repair work required.

Sash window spring balance repair: I have a tilt-to-clean 1000x1300mm wooden spiral balance sash window from a 1990s building (SE16 5EE) that includes support bars to hold the window at an angle when tilted. The bottom half of the window was blown open into the tilt position in high winds a few weeks ago. I was able to rotate the sash back into the frame so it is vertical again. Now the left side is stuck open (about 4cm from the bottom) and won't slide up and down; the right side is fine. The tilt latches must have come undone to enable the wind to blow it open.

Repair broken sash window cord and make good - may require bead to be re-caulked but painting will not be required.

Spring mechanism of a sash window needs replacing and refitting (including buying the piece).

Looking to rectify water damages to the im window/ door framework

Need help repairing broken Sash windows. I believe it’s the spring balancers that require replacing. It’s very loose in its frame and the counterweight seems to have become detached so it can only be opened with difficulty.

The lock on the sash window is lose and therefore cannot lock the window securely. The lock may require replacing or repairing. I have a video that better shows the actual issue, but unfortunately I am unable to upload onto the app, but I can send it to you separately.

I need help fixing a sash window handle that has come off.

We have a problem with both sash window in the room. They don’t open and apparently the issues are with metal spirals. Could you let us know roughly how much is the charge and availability? Regards,

One of my sash windows has become increasingly stiff and difficult to open and close. The window can still move, but it’s sticking due to friction along the side tracks, possibly from paint buildup and wear. I need someone to: • Gently loosen the window if needed (without causing damage) • Lightly sand or clean the sliding tracks if necessary • Lubricate the sash tracks (preferably with a dry silicone spray, not oil-based lubricants) • Check the sash cords for basic condition (no need for a full replacement unless necessary) • Make sure the window slides smoothly again without excessive force Important: • No heavy force or removal of the window needed — it still moves. • Please bring your own tools and materials (fine sandpaper, silicone spray, etc.) • Care needs to be taken not to damage the paintwork unnecessarily.

Cord hung sash window (154x97cm dimension based on inner box frame) needs replacement of side vertical beads with draft proof brush (brush worn out). The left bead is broken in two. The right is worn out so both need replacement.

Looking to have cord repaired which has snapped on sash window, only on one side

First floor flat with heavy 53lb wooden sliding bottom sash needs spring balances tightened

We need the cords replaced in 2 sash windows to open and close. Will need own ladder and tools. Materials will be purchased when discussed.

Top half of one sash drops slightly so window can't be locked

I'd like to install three sets of locking secure stops across two sash windows. I have one set of two installed previously, meaning the bottom sash in one room can only be lifted about 15cm. I'd like to do the same to the top sash of the same window . I'd then also like to install four more stops to get another window to the same state, where both the top and the bottom sash can only be moved by 15cm

I have bought 2 bronze barrel-style window stops to replace old ones, which now need screwing into a sash window frame. It should be straightforward. You can see from the photos we had to remove old ones because we lost the key so the new holes will go under the circles you see in the photos. It should involve drilling 2 holes and screwing the barrels into the frame so that the stopper can prevent the window from opening past a certain point. I’ve also included a photo of another window to show you what it will look like when complete. Thanks