Find a professional staining service near you

I spilt an oil diffuser on my sideboard and it has left the below stain Are you able to give me a price/let me know if you can fix the below stain and return the wood to its original form? Here is a link to my sideboard https://www.daals.co.uk/products/maru-large-4-door-sideboard-oak?variant=55409500291458&country=GB&currency=GBP&utm_medium=product_sync&utm_source=google&utm_content=sag_organic&utm_campaign=sag_organic&utm_source=google&utm_medium=cpc&utm_campaign=17058647490&utm_content=&utm_device=c&gad_source=1&gad_campaignid=17063444530&gbraid=0AAAAAC5PeAzAk7QflzKYJY_6MdT5Zl3at&gclid=CjwKCAjwtp7VBhBjEiwAJfpV-01tjxo_tVKBfHTFX4Mvv_iI_Yzb-hl6glqYLQKAXNgmIXcXAqL-5RoCKNwQAvD_BwE. Please note, only respond if you are sure you can restore the wood to it's original state. Will not be paying if it's only half complete

I’m looking for someone experienced with vinyl/contact paper wrapping to wrap all 4 cabinets shown in the photos in a stainless steel look. I attempted to wrap one of the cabinets myself, as shown in the photos, but I’m not happy with the result. The contact paper I have already applied will need to be removed and redone. I’m looking for a clean and professional finish, particularly around the edges, corners and doors, with no bubbles or obvious seams.

Help to plumb in a small sink in my utility room

Tea thrown at white ceiling and wall, and its stained both of them. Inside a kitchen.

Garden office shed sand, stain and oil

I need an experienced kitchen fitter or handyman to re-seat and re-seal a top-mount stainless steel utility sink set into a granite worktop. Access: ​Wide-open access under the cabinet (plumbing is standard flex/plastic). ​Job Details & Requirements: ​The Issue: The original sealant has degraded, causing the metal rim to lift away from the granite cutout. ​Clamping System: The sink uses built-in spring-loaded / press-fit serrated clips along the underside track (no manual tightening screws). Because the granite is hard and smooth, these clips cannot bite into the stone, so the repair relies entirely on proper surface prep, a strong hybrid polymer sealant bond, and temporary weighting. ​Required Scope of Work: ​Isolate the water supply (isolation valves are easily accessible directly under the sink) and disconnect flexible waste/trap pipework as needed. ​Lift/remove the sink completely. ​Crucial: Fully scrape off all old silicone, foam tape, and old yellow glue residue from both the granite cutout edge and the metal clip track. Wipe down with a solvent degreaser (isopropyl alcohol or acetone). ​Apply a generous bead of high-tack hybrid sealant (e.g., CT1, Stixall, or high-grade sanitary silicone) along the rim. ​Re-seat the sink, clean off all squeezed-out excess sealant, and place heavy weights (e.g., paint cans or water buckets) across the edges while it cures. ​Reconnect plumbing and test for leaks

Few touch ups on the wall and removal of stains

Just wall painting and nothing much

Painting of few spots on the wall from picture frames and headboard scratching the wall.

Hi, I need my existing stair banister/railing replaced with a modern brushed stainless-steel balustrade. I want 304-grade stainless steel, satin/brushed silver finish, with stainless posts, handrail and vertical bars. Please include: * Removal of the existing banister * Measuring the staircase * All stainless-steel material and fixings * Fabrication/welding where required * Supply and installation * Making good any holes/damage after installation

I have these fences to paint, newly installed. Both sides painted. X9 normal fence x5 high slatted X4 low slatted

The area of decking is approximately 6m x 2.5m. It is three years old. It needs preparing and then two (?) coats of stain. I can provide materials.

Painting kitchen dresser (has v old coats of paint on). Staining & sealing 2x kitchen worktops. Painting kitchen sink unit (currently just treated wood) and staining & sealing the worktop. Wall paint touch-ups. Paint a radiator. Paint an Edwardian fireplace surround. Paint bannisters & spindles (old paint with chips).

I need the staining of two window frames (1st and ground floor) on a rental property in Leigh. Date to be organised with tenant.

I posted a similar job recently and we had someone come in who we have used previously to remove all garden tile stains but unfortunately they were unable to seal the tiles. So I am posting again. We need some further small stains to be removed (it will not take long as most of them have already been removed) and most importantly, we need our tiles to be sealed with an excellent garden tile sealer to prevent further future stains and to protect our porcelain tiles. You must be professional in having this kind of experience and I will be looking at reviews. thank you!

heavy duty stainless steel anchor hook to be fixed to the ground (concrete) on a tennis court.

There are some stains around the light switches and lower parts of the wall after a tenant left. I want only the stained part to be repainted.

Paint a piece of the wall in the kitchen that has been stained yellow, also silicon resealant needed in that part.

I'm looking for a reliable and experienced professional to carry out the following work at my property: Fully paint both sides of the garden fencing, and a bench. Around June/July 26. Using Ronseal creosote I’d provid. The trader will need to have own equipment, rollers, brushes, etc. The job is intended to be completed unsupervised. Extreme care must be taken to avoid any drips or damage to the newly installed resin-bound boundary area. Requirements: Must be capable of working independently and unsupervised. Careful, tidy, and experienced with exterior wood treatment. Regular updates via WhatsApp during the job, including photos of completed work prior to payment being released. If you're confident in delivering high-quality results with minimal oversight, I’d love to hear from you. Kind regards, Joe