Find a professional hot water system contractor in Central London

Hi, I need an urgent visit from a Gas Safe Registered engineer to fix my Vaillant ecoTEC Plus boiler. ㅤ Currently, we have no hot water. The boiler display is showing a pressure of 2.8 bar, which is in the warning zone. I have tried to reset the unit, but it is not firing up. ㅤ Requirements: • Must be Gas Safe Registered (please provide your ID number in the offer). • Experience with Vaillant ecoTEC models. • Task involves: Safely reducing system pressure, checking for a faulty filling loop or expansion vessel issue, and ensuring the boiler restarts correctly.

Fix low hot water pressure (electric system) – kitchen tap only Description: I need someone experienced with plumbing / electric hot water systems to fix low hot water pressure in my kitchen tap. Details: Property: Flat in Tooting Issue: Hot water pressure is low in the kitchen only Cold water pressure is fine Bathroom hot water appears normal System is electric (not gas) What I need: Diagnose the cause Fix the issue if possible during visit Requirements: Experience with electric water heaters / plumbing Must bring own tools Please mention relevant experience in your reply Flexible on timing but ideally ASAP. Please quote for labour and mention if parts would be extra.

The extractor fan for the bathroom doesn’t seem to be working which’s causing humidity to form in the adjacent bedroom (mould spores under mattress as a result). Need the extractor fan to be functional & to turn off with a timer. I’m not sure exactly where it’s located though. (Flat is currently tenanted- so sadly I can’t be there to assist). Hot water temperature needs to be adjusted in the shower… Tenants are saying that the water is scolding hot.

Install new hot water tap to replace old one - under kitchen sink -should take 15/20 mins

Remove old electric water heater, install new(relocated)

No hot water in flat. All taps - cold water running just fine

Experienced plumber needed for unvented/mains-fed hot water cylinder leak (white tall model in airing cupboard). White plastic overflow/vent pipe on outside wall leaking, causing damp patches and moss growth. Tasks: inspect/diagnose source (valve/immersion/seal); repair/replace parts; check system pressure, fix minor wall damage, tidy up; test hot water/immersion.

Main boiler water hot and cold

Water heater issue as outlined

Water heater Vailant ecoFIT Pure has issues, water pressure went down, and now F.75 error I need someone to fix

My bathroom hot water is very low

Hot water tap dripping, and the radiator valve is faulty.

I have a water pump, but the hot water is very low, doesn’t even fill up a bath

The elements are leaking with the water touching the electrics it’s cause the mcb to trip, the spur switch is burn out, ( please see picture ) The 210 litre cylinder will need draining down to replace the elements due to the rust build up this has welded the elements which will prove hard to remove

Hot water pipe and coupling to be installed on electrical water heater. New plastic Leakage Firewall needed to be installed and the old one removed

Our current Ariston water heater has died, we're looking to replace the unit with a new one, removing and disposing of the old one.

Studio flat has only 7 min of hot water, we would like to have continous hot water, or at least 20, 30 min. There is a 100 litres water tank and no boiler available.

Shower tap doesn’t produce hot water (limited flow when turned to hot). Normal hot water elsewhere. Most likely seized thermostatic cartridge.

Need a plumber to fix hot water - shower and taps all run cold so it’s not the appliances - the heat pump is also working and was just replaced two months before

I have a megaflo unvented cylinder. It currently works when I turn on the boost but it doesn’t have hot water when i leave it on timed. Would like to get a third party opinion whether the cylinder is working. Just needs checking.