Find a trusted local electrician in Hertfordshire

Its a louvolite electric blind stopped working tried all the fixes in instruction and on line but need professional help

Installation of my cooker

Disconnect and dispose of gas hob. Cut countertop to size as it is currently too small to accommodate new induction hob. Then install new induction hob

Cooker hood need replacement, you can source or let me know which model will work

I have a commercial unit and I need a sink moved and plumbed in. Frankly the existing plumbing thats there is a bit of a shambles but there are water lines and drainage already in place to connect to (may need a 90° ½" connector to connect flexi pipe), it would be a matter of cutting the existing waste pipe using a tee and a little pipe work (maybe a 135 bend to bring it up to level) then connect a trap to it. Also to cap of the end of the existing waste. The kicker is this is all 1.5 solvent waste. Also I need someone gas safe and competent to help me disconnect a cooker.

Find a fault and fix my mirror in my bathroom it’s hot 24/7 doesn’t switch off

Light section where light bulb goes totally broken, needs removal and replacing , see photos

I had an electric blind fitted in my lounge window a couple of years ago but the motor seems to have stopped working as it stopped taking a charge around 6 months ago and now doesn’t even activate blind movement when plugged in. I am looking for a replacement of the motor but not the blind

Remove 2 small wall lights from their sockets and make whatever is behind them / the electric safe so we can rest furniture against the wall

The bathroom light pull switch needs fixing. The lights under the kitchen cupboard and in cupboard have stopped working

Lamona extractor hood needs repair and I’d repair is not possible might need advice on replacement for either parts of the whole system

Replace extractor hood for kitchen.

Need flood lights and cameras installed at the front and back of house

I am attempting a science project where I am creating a zip wire model to convert kinetic energy to electrical energy i.e light an LED. Need someone to help me set up the circuit and make the LED light up.

I need an electrician to do this: 40 amp fuse to replace 32 amp and possibly a 10 milimetre cable run from fuse board to cooker terminal

My electric triton shower unit need attention as the water comes out very slowly and makes a buzzing noise

My 2 bar fridges work but won’t hold temperature. They keep dropping to zero degrees and freezing the drinks in there. Have already changed the thermisters

Looking for a qualified battery-storage installer in the area to put in a myenergi libbi 5kWh system with the 5kW integrated inverter and have it installed as a battery-only system — there will be no solar. Details: Property is a second-floor/top-floor flat Proposed location is inside a large living room, against an internal wall Good ventilation and plenty of space around the proposed location Libbi weighs approximately 54kg I already have an approved DNO connection and can provide the relevant documentation Could you please confirm whether you: Are qualified and experienced in domestic battery/EESS installations Have experience installing myenergi libbi Are comfortable assessing/installing a battery in a second-floor flat under the current BS 7671 / PAS 63100 requirements

I need to replace this faulty cooker extractor hood with fan. The hood recirculates the air (not extract). I can purchase the fan, I just need someone to fit it.

Experienced bicycle/e-bike mechanic required in Abbots Langley, Hertfordshire to service and repair a large Alpine electric fat-tyre trike. I am looking for a comprehensive service, not just a basic safety check. Work required: • Front tyre has an active leak — inflates to 30 PSI but goes completely flat again within hours. Diagnose and properly repair the cause. • Rear tyre has a slow leak and also needs diagnosing/repairing. • Full hydraulic brake service/bleed and brake pad inspection. • Wheels, spokes and wheel alignment checked. • Headset, steering and bearings checked and adjusted/regreased where required. • Drivetrain checked, cleaned and lubricated. • All important bolts/fixings checked and tightened. • General inspection of the electric-bike connections. • Full clean/service of the trike. The trike has fat tyres and an electric hub-motor wheel. You MUST have genuine experience servicing bicycles/e-bikes, including hydraulic brakes. Experience with electric trikes, cargo bikes or fat bikes is strongly preferred. Please tell me what bicycle/e-bike repair experience you have when making an offer and whether you can complete the work at my home. Parts such as inner tubes, tyres or brake pads can be paid for separately if required, but please agree any additional costs with me before fitting them.