Find a professional hot water system contractor in London

boiler showing E01 error. Reset attempted but still no heating or hot water. Looking for a Gas engineer to diagnose and repair the issue as soon as possible, preferably in one visit.

We have a Low pressure Hot water system - the Shower wont work, we need to verify if a Electric shower or A twin-impeller pump would work.

I need a water heater installed. There was one in previously but it was leaking so needs to be replaced with a new one. I also need some plug sockets changed and a plug on a hoover changed. Thank you

Description: Persistent water leak/discharge around a Megaflo hot water cylinder. Water is currently being collected in a bucket which needs emptying a couple of times per week. There is visible limescale/corrosion around some of the cylinder fittings and valves. Exact source of the leak is unclear. Looking for an engineer experienced and appropriately qualified for unvented hot water cylinders to inspect, diagnose and repair the problem. Photos attached.

Looking for an experienced heating engineer to inspect a heating issue at our property in W2, Paddington, London. The hot water is working normally, but the radiators are not heating up, despite the thermostats being switched on. We need someone to diagnose the issue and, if possible, fix it during the visit. Budget: £65 for the initial inspection. Ideally looking for someone available today. Please confirm your availability. Thank you!

Need a G3 qualified engineer with electrical skills to fix a recurring hot water fault in my Hackney Wick flat. Megaflo unvented cylinder on a communal heat interface unit, no gas. The timer shows ON but the pump stays dark.

I need someone to help us install a water heater. Its the Andris Lux 15L Under Sink Water Heater.

I have an old and faulty actuator for my boiler/underfloor heating systems that needs to be replaced. I'm holding the new one in my hand, it needs to be installed onto a brass body and also its electrical wires need to be connected to the green connector on the bottom right hand side of the picture

Sensor that triggers hot water has gone water only in the shower keeps going cold

Have a slow leak coming from the hot water tank (it appears) or piping under the sink in the kitchen.

We have hot water issue for a while and the previous plumber said it was due to the pump. Also the immersion all of a sudden stopped. Need fixes for both

Our machine machine is connected to the hot water pipe - we need it moving over to the cold pipe

No hot water and pressure is down.

I have purchased a replacement kitchen tap which needs installing. The existing hot tap is faulty and leaks when opened. The fitting underneath the existing tap is extremely tight and I have been unable to remove it. Please remove the existing tap and install the new one.

I have a boiler which has stopped working. I showed it to a plumber and he told me it needed a new Hot Water Actuator Valve but is quoting me ridiculous price for it when I know it is not that expensive. I need a plumber who can source this and fix my boiler.

Moved into a new property. Had the washing machine connected and they said they couldn’t connect the dishwasher. Now we are noticing lots of water pushing up the floorboards in the kitchen. Also, couldn’t run a hot bath last night

We have had no hot water or central heating for several weeks and need someone to diagnose and repair the system. We have: Baxi boiler Elson Zircon 210i, 210-litre indirect unvented hot-water cylinder Google Nest controlling the heating and hot water Please only respond if you are experienced with Baxi boilers, unvented hot-water cylinders and motorised valves/central-heating controls. Will provide any pictures required.

Hot water not working. Display unit on boiler is off. Can’t see light or writings on it

I need a qualified boiler/heating engineer to check and fix my boiler, as the hot water is currently not working. Ideally, I’d like the problem diagnosed and repaired during the visit if possible. If parts are needed or there will be additional costs, please let me know before carrying out the work.

Downstairs kitchen hot water tap handle is very hard to turn and open. Needs fixing or replacing. The ceramatic valve may need replacing. (Not sure if this is the cause but looks rusty.)