Find a professional hot water system contractor in London

Hot water dial is a bit broken but even before that the hot water wasn’t getting hot. Other taps in the property are fine

The extractor fan for the bathroom doesn’t seem to be working which’s causing humidity to form in the adjacent bedroom (mould spores under mattress as a result). Need the extractor fan to be functional & to turn off with a timer. I’m not sure exactly where it’s located though. (Flat is currently tenanted- so sadly I can’t be there to assist). Hot water temperature needs to be adjusted in the shower… Tenants are saying that the water is scolding hot.

Install new hot water tap to replace old one - under kitchen sink -should take 15/20 mins

Bath tap gets fully hot, but shower stays only lukewarm even with the shower head removed. Likely fault with the concealed mixer diverter or thermostatic cartridge. Looking for diagnosis and front-access repair/replacement.

Hi, We’re looking for a qualified plumber/handyman to replace a faulty cartridge in the bathroom because the hot water isn't coming through properly. Kindly include your availability and offer for this task. Thanks, Victoria

Adjust a water pipe to increase water pressure

Remove old electric water heater, install new(relocated)

No hot water in flat. All taps - cold water running just fine

Water is not heating and is like warm no help from landlord needs fixing asap

Experienced plumber needed for unvented/mains-fed hot water cylinder leak (white tall model in airing cupboard). White plastic overflow/vent pipe on outside wall leaking, causing damp patches and moss growth. Tasks: inspect/diagnose source (valve/immersion/seal); repair/replace parts; check system pressure, fix minor wall damage, tidy up; test hot water/immersion.

We are currently undergoing a house renovation and our gas supply and combi boiler are disconnected for several months. I need a plumber to install a temporary electric hot water cylinder (approx. 100L with immersion heater) so we have hot water for showers and taps during the build. Scope of work: • Install wall-mounted or floor-mounted 100L electric hot water cylinder • Connect cold mains feed to cylinder • Connect cylinder outlet to existing hot water pipework feeding upstairs bathrooms • Install necessary valves, pressure relief and discharge pipe • Connect to existing fused spur / electrical supply for immersion heater (or advise if electrician needed) Context: • Property in London (IG8 area) • Two bathrooms on upper floors that need hot water • Boiler currently disconnected due to renovation works • Cylinder location flexible (loft or first-floor bathroom depending on practicality) Requirements: • Qualified and experienced plumber • Ideally G3 qualified if installing an unvented cylinder • Must supply small fittings and valves required for installation Goal: Provide temporary hot water for showers and sinks during a 4–6 month renovation. Please confirm availability and approximate installation cost.

Main boiler water hot and cold

Water heater issue as outlined

Water heater Vailant ecoFIT Pure has issues, water pressure went down, and now F.75 error I need someone to fix

Hi I need my under sink water heater replaced I will provided the water heater

My water heater is not working (the water only heats up to 21 degrees) and the timer is also not working (there seems to be no current flowing through the cable). I would like someone to diagnose and fix the problem.

Our ideal c24 boiler isn’t producing hot water properly. Sometimes it’s not very hot, sometimes hot but have to run taps on low pressure. Otherwise running fine, radiators working etc

Our electric shower has just randomly stopped working and need someone to come and take a look at it urgently. I’ve bought a new shower head as I initially thought the issue might have been he hose but after installing it stiill issues - need someone to coome asap - thank you

The hot water tap on my shower has stopped working properly. When I twist the hot water handle, only a very small amount of water comes out. Cold water still works normally. This started recently 2 days ago, no visible leaks. Looking for someone to inspect, repair/replace the tap or internal valve if needed.

Studio flat has only 7 min of hot water, we would like to have continous hot water, or at least 20, 30 min. There is a 100 litres water tank and no boiler available.