Find an experienced gas fitter near you

Old gas cooker pipe. Previously capped. Potentially leaking. Needs testing / re capping.

Existing 60cm built-in gas hob needs removing and replacing with a new electriQ 60cm 4 Burner Gas on Glass Hob (EQGH6042VOL). The current hob is connected with a fixed copper gas pipe, so this may need minor alteration/reconnection to suit the new hob. The existing worktop opening measures approximately 559mm x 495mm and the new hob specifies a 560mm x 490mm cut-out. There is a built-in oven directly underneath which can be removed for access, and a standard electrical socket is already there for the hob ignition plug. Please include removal of the old hob, fitting and connecting the new hob, any minor gas pipe adjustment required, and full gas safety/leak testing. Gas Safe registered engineer required.

We have a mega flow system but at the moment our tenants have no hot water. It was working fine before.. it may just need resetting

My Countrychef range cooker oven ignites, but the flame goes out immediately when I release the control knob. I suspect the thermocouple or flame-failure device. Please confirm your total call-out charge and whether parts and VAT are included.

The closet I'm converting into a laundry space also houses the gas meter. Need a Gas Safe registered engineer to confirm: • Whether a washer-dryer can safely share the enclosure with the gas meter • Any ventilation, clearance, or separation requirements this creates • Sign-off/documentation I can pass to my builder and electrician Second-floor flat, Altrincham WA14. Flexible on timing — just need a written assessment I can act on.

Replace gas hose, connect gas tank connector

To remove gas Hob 60cm and replace for new. Same size straight swap and to do tightness test and provide certificate

We have two old gas pipes that are sticking up above the floorboards. We need them both cut and capped below the floorboard (one is inactive but unsure on the second)

I’m renovating a house in Bloxham, Oxfordshire and need an experienced plumber who is also Gas Safe registered to carry out the plumbing and gas enabling works before the main demolition/construction starts. The house is already substantially stripped out. The work required includes: • Keep the existing annex water supply live while allowing the main house to be isolated • Drain down the main house heating system • Cap/isolate redundant water and heating pipework • Disconnect and make safe the existing boiler • Isolate/cap any gas pipework affected by the renovation • Leave the main house safe and ready for the next stage of demolition/construction I’d like someone to visit the property first, assess exactly what is required and then agree the works before proceeding. Must be Gas Safe registered and experienced with renovation/refurbishment work. Property is in Bloxham, near Banbury.

Greenstar combi & gas oven both < 3 years old cerfification required.

We have had a gas fire removed and now need the gas tap to be removed. It is set in concrete not the floorboards.

I have replaced an old dual fuel cooker with an electric one and need the old gas feed capped off.

I have a portfolio of properties and need gas certs carried out throughout the year looking for someone who uses a system and that it gets sent via email rather than paper form

Disconnect and remove gas hob replace with electric one

Need a new regulator fixed to hose on propane gas barb q a Weber Genesis 11 and check over

Connect cooker to the gas line

Relocate gas pipe back to right wall for cooker

We need someone to disconnect an electric and gas cooker to connect another electric and gas cooker

I’ve got a capped gas pipe sticking through my wooden floorboard. I’d like this cutting down by 10cm so it’s sits under the flooring, board is already removed for access. Also a radiator needs dropping in order to decorate a room

I have had running to my hob and oven and just want this capped off as I don't need it anymore Cheers Let me know if you want to come and see first