Find a local floorboard profesional near you

The floorboards have come up and uneven - carpet underneath

I need my floorboards levelled in my office on the second floor in preparation for a subfloor, they slope down to the hallway/landing. They are are at the lowest 5/6mm different. Some will also need fastening to stop the squeaks.

I need my floorboards done up again I have purchased some new tiles I want installed in the kitchen floor and downstairs entrance please get in contact with me and let me know your Quotes

One room floorboard securing to reduce noise and squeaking Need a professional job. The previous person caused severe damage to the flat below due to lack of knowledge - very expensive repairs incurred

Living room and hallway skirting boards to be sanded and repainted white.

Need soneone to help cut like 5 short pieces of 2x2 timber to support 2 runs of floorboards, screw the floorboards down and replace the carpet in a small room. It is the small holes in the photographs and should take 2 to 3 hours

I’m looking for a flooring expert to replace approx 6 boards in the kitchen and about 7 in the main living room as shown in photos. In the living room/ hall it’s a case of replacing individual boards rather than taking up all of the boards / surrounding boards. Hopefully this can be done with appropriate tools/ knowledge 😊

I tripped over the lino floor and now it has raised and creaks when you walk over it. I would like someone to repair the area so that the floor is no longer raised and doesn't creak. It's just one area of the floor, in the hallway. Looking for someone with flooring/lino experience. Thank you.

We are getting new carpet in and need to fix loose floorboards before carpet fitters come to lay new underlay and carpet. One board is completely off and the surrounding floor boards (about 3-4 also feel loose-ish) need to fix these down without damaging active pipework underneath. Carpet does not need to be preserved as will be removed anyways (except carpet grippers which will need to be left in tact for new carpet)

My laminate floor boards have lifted only a few

I need cement boards installed to stud walls and floor in a 1.8mx2m em-suite. I also need someone to cut and install 18mm plywood sheet to a small 1.1mx0.8m WC floor. All materials provided.

I need a flooring professional to replace two damaged herringbone LVT plank in my kitchen/living area. The flooring is click-system LVT, and fortunately there is access to the flooring from underneath/behind the kitchen panel, so the surrounding floor should be able to be carefully opened up to reach and replace the damaged plank. What needs doing Carefully dismantle the LVT flooring from the accessible kitchen side Remove the damaged planks Fill small section with self levelling compound or something similar to ensure the same issue does not occur again. Replace it with a matching planks (I can provide the replacements) Reinstall the flooring and ensure all joints are properly locked and the finished area is level and neat Avoid damaging the surrounding planks I've attached a photo showing the damaged area. Looking for someone experienced with herringbone click LVT flooring.

A section of the loft conversion has broken floorboards. A small section in the shower room too. Ceiling fell from bedroom below after daughter went in without authorisation. Main lounge needs tiling.

Rotten floorboards have been ripped out so new ones need putting down, damp proofing and the base securing and levelling

I need somebody to finish the last line of laminate flooring to fit under the door frame. I have all the materials and some tools to help if needed

Floorboards are squeaking underneath carpet on landing in 3 areas. Also in very small area of 1 bedroom and also in another bedroom. Am looking to get help to stop the squeak

Floorboard Sealing & Door TransitionHandyman/carpenter needed in Didsbury for a quick floor tidy. Boards are good; no sanding. Must finish by next Tuesday/Wednesday.Clear debris from gaps.Seal floorboard gaps flush (DraughtEx or foam/filler).Pack/caulk deep corner hole and gap along white skirting.Cut and secure metal transition strip between Amtico and wood doorway.I will provide materials. Please bring tools and shop vac. Send rates/availability.

Removing carpet, then removing paint from floorboards, and sanding down and varnishing hardwood flooring. Room is 4.5 x 5m

The subframe will already be built and level, but I just need someone to cut and screw down the hardwood boards. I have all the materials, tools and mitre saw. I’m just short of time and need to get it done by Friday. Just looking for some with the skills and experience to do the job professionally.

The scratches on the floorboards need sanding and filling we have a kit