Find a trusted local electrician in Essex

existing 100mm in line extraction system in place, but no air extraction. In an accessable loft space. Needs attention. Maybe new pump?

Circuit for spotlights in the kitchen does not work. Rest of the lights in the kitchen work fine, potentially just needs one of the bulbs to be replaced, but not too sure. There are also some spotlights that need putting in for the living room after the room was re-plastered. The plasterer had covered up where 2 spotlights were, and they need putting back in. Fire alarms also need looking at. Again, not sure if anything needs replacing but they need a re-install at a minimum.

Need some elctric wiring / some fixing

Looking for a qualified electrician to complete a few straightforward lighting jobs in a ground-floor maisonette in Woodford Green (IG8). Jobs required: * Living room: Install new ceiling light (old fitting already removed). * Hallway: Remove existing ceiling light and install replacement. * Main bedroom: Remove existing ceiling light and install replacement. * Second bedroom: Remove existing ceiling light and install replacement. * Garden: Remove existing floodlight and install new PIR security light. Old light flashes once but doesn’t stay on, so wiring/supply needs checking. * Bathroom: Check stiff light switch and repair or replace if necessary. All five new light fittings have been purchased, although I’m waiting for a few deliveries. Ideally looking for someone on Thursday 22 October, with all work completed in one visit. These should be straightforward jobs. Please confirm your electrical qualifications, availability and whether your quote covers installation and testing.

I am looking for an experienced plumber with Hive smart heating installation experience to complete all work during a single visit. Job 1: Install Hive Smart Heating System I will be supplying a Hive smart heating system, including 6 Hive Smart Thermostatic Radiator Valves (TRVs). Scope of work: • Install and configure Hive Hub • Install and connect Hive Thermostat and Receiver to my existing boiler • Replace 6 existing radiator valve heads with 6 Hive Smart TRVs • Pair all devices with the Hive app • Set up room-by-room heating controls and schedules • Test and commission the entire system • Ensure each radiator can be controlled independently via the Hive app on my iPhone • Provide a brief demonstration before completion Please only apply if you have previous experience installing Hive thermostats and smart radiator valve systems. Job 2: Replace Kitchen and Toilet Taps • Remove existing kitchen tap • Install new kitchen tap (supplied by me) • Remove existing toilet/cloakroom tap • Install new tap (supplied by me) • Test all connections and check for leaks Requirements • Plumbing and basic electrical experience • Proven experience with Hive heating installations • Own tools and equipment • Ability to troubleshoot and fully commission the Hive system • Clean and tidy workmanship • All work to be tested and demonstrated before leaving Additional Information • Property located in Harlow, Essex • Photos of the boiler, thermostat, radiators and taps can be provided in advance • Hive equipment and replacement taps will be supplied by me unless otherwise agreed Please Include • Details of your Hive installation experience • Total labour cost for the job • Estimated duration • Any additional materials that may be required • Earliest availability Preference will be given to applicants who can complete both the Hive installation and tap replacements during a single visit.

We need a person to remove old electric cooker and gas hob and fit new electric oven and gas hob

I have Electric blinds which will not charge . I have a hand disability which doesn’t help

Need a car charger installed.

Karcher K4 pressure washer switch does not turn on the pump when turned to “on” position. I changed the fuse in the plug but no difference.

Chasing/recessing 4 existing sockets in to wall. Moving living room light to the centre of the ceiling and fitting a light fixture in hallway above stairs.

I need a disconnecting Grays and a reconnect in Purfleet and it’s a Council property both of them. So it has to be a certified electrician.

Electric armoured cable to be fitted along a 4m fence and connected from outside socket to fuse box in summer house. All other electrical fittings have been done.

I need an electrician to replace 2 existing integrated LED downlights in my kitchen in my home in Epping, Essex. Both lights have stopped working and are approximately 8 years old. I believe they are Aurora Enlite E8 fittings (possibly EN-DE8/30, 3000K warm white), but I would like the electrician to confirm the correct replacement before purchasing. The job would involve: * Removing the 2 existing faulty lights * Installing and connecting 2 suitable replacement fittings * Reusing the existing bezels if suitable The existing ceiling holes and wiring are already in place, so this should be a like-for-like replacement rather than a new installation. I am happy to source and purchase the replacement fittings myself if the electrician can confirm exactly which fittings I need to buy. Alternatively, I’m happy to consider supply and fit if that’s easier. Please quote for the job, either labour only or supply and fit.

I need a multi-skilled handyman in Colchester to replace my kitchen extraction setup. I have a brand-new Haier 60cm black chimney cooker hood (arriving this Sunday) and a brand-new 60cm (W) x 80cm (H) WilsonArt Alloy aluminium marble-effect splashback panel (arriving next Wednesday from Very). Looking to have the work completed on Saturday 26th September. Tasks Required: Protect the brand-new Bosch induction hob below before starting. Safely remove and dispose of the old stainless steel hood (wires are entirely hidden inside the vertical chimney casing). Remove the old loose splashback panel. Repair the damaged wall anchors and plasterboard behind the hood zone to ensure the mounting structure is 100% solid and secure. Mount the new WilsonArt Alloy splashback panel seamlessly to the wall. Securely mount and connect the new Haier black hood over the top so it neatly overlaps the top edge of the splashback. The existing ducting kit is already in place. Please bring heavy-duty wall fixings/plugs and suitable high-bond adhesive for an aluminium composite splashback panel.

I have a single recliner and 1 part of a double recliner that have stopped working.

installing a two chandelier lights

I need help changing a light fitting and finding which is a live wire

Installing lighting fixtures and hardwired door bell

I need assistance with the assembly of bbq appliance

I need a 3 way light replaced with a 42” fan in the front room