Find experienced local tradies in Outer West Sydney

This project involves the professional preparation and application of a render finish to the exterior front wall of a house facade and painting the walls after rendering. The goal is to achieve a durable, weather-resistant, and aesthetically pleasing finish that enhances the property's curb appeal. Rendering is required to front side only. Elevation and floor details are shared for sizing and estimation

Moving house and need help with minor plaster repairs and touch-up painting for small areas. However, it’s also possible that the entire wall needs painting, which could make the property look fresh and inviting. Starting tomorrow or as soon as possible.

2 gang switch replacement.

Box awning with drainage. Have to comply with council.

I need help installing an Instahut Outdoor Blind Privacy Screen Roll Down Awning Canopy on my brick veneer property. Looking for a fixed-price quote Details: - Blind size: 2.7m (W) x 2.5m (H) - Property type: Brick veneer - Requires masonry drill bits (14mm and 6mm) for installation I will handle assembly of the blind itself. Just need assistance with - Drilling holes into brick veneer - Securing screws and wall plugs - Mounting the blind brackets and fixing the blind in place Requirements: - Must have own drill, masonry bits, and appropriate fixings for brick veneer - Experience with outdoor blind/awning installation preferred - Job should take less than an hour Product link https://www.bigw.com.au/product/instahut-outdoor-blind-privacy-screen-roll-down-awning-canopy-window/p/9900205468?srsltid=AfmBOoo0XNKjZkX6cogZKs7T0aMs6onmGAGDETYdJ4Is7_XbSpmEcnGp

Gyproc required around new door recently installed. Door will have architraves installed around frame - Curved Gyproc required around rangehood (have purchased 6.5mm curved Gyproc) will be provided for the job - Cornices required to be supplied and fitted into new kitchen plus above new door

I need to replace 6 or more power points

I have a feature wall that needs to be taken down. Previous owners have glued timber floorboard material on the walls. Need someone to remove it and smooth the walls ready for painting. Approx 4m length of wall

I need an experienced gyprocker who can also finish off some light internal carpentry around two skylights in separate bathrooms. The skylights have been installed, but the internal framing hasn’t been fully completed by the carpenter, so I need someone who can: • Complete the internal timber framing where required • Install gyprock around each skylight opening • Set, plaster and finish the gyprock to a paint-ready standard • Ensure clean lines and a neat finish around the skylight frames (wet-area appropriate) Both bathrooms are fully tiled and accessible. Photos attached for reference. Requirements: • Must be experienced with gyprocking in bathrooms / wet areas • Comfortable finishing small carpentry sections as part of the job • Bring all tools and materials needed (happy to reimburse materials with receipts) • Available ASAP Location: Blaxland Flexible with dates — need done before Christmas

There are several big cracks in the curved steps that continues onto the front verandah. I would like these repaired to paint later.

Plaster a small whole in wall made by A/C installation. Materials will need to be purchased or I can supply materials.

Dissemble sauna that have glass panels. Need to be careful so nothing breaks. Can run you through how to dissemble it if need be. Also needs to be relocated to Jamisontown.

Seeking an experienced plasterer or builder to install insulation and plasterboard on a ceiling, followed by ceiling preparation and painting. Scaffolding will be required at the main entrance due to a large staircase. The room size is approximately 80 m². Please contact if you are available and able to provide a quote.

Run a new circuit apprx 10m and conn3ct sauna up that has a 4.5kw heater

I need some cornice installed and some gyprock repaired

There is a very small gap inside the space for microwave. Some bugs are coming from the roof, so I need it to be closed.

Painting or rendering (depending on what’s recommended)

Hi i need 1x power point installed in the roof for security cameras

Fill holes in walls touch up paint two walls.

Acylic coloured texture over the top to match existing wall