Find a professional render contractor near you

Patch and render section of wall. The existing wall is render over foam. ~3m x 0.5m

I’m looking to have someone repair and re-render a small facade which is approximately 3000mm high by 5500 mm wide. Note that part of the facade is already painted and the area across the top to the garage door is marine ply. I have a few length of corner bead on site.

Rendered masonry boundary fence (~8–10m long) (front and back) need repainting. Surface prep + 2 coats required. Colour is an existing white tone to match on site). Quote separately for bathroom ceiling(install a 300x300 access panel) and gyprock and paint Easy street-front access. Please quote with materials

Attach fold down clothesline to rendered brick wall.

I need a renderer to cover up a small man hole at the front of the house. Matching the colour of the house.

Removing Air conditioning unit, 2x Plaster patches. · 2x Render patches. · spot priming of bare surfaces. 2x Plaster patches. · 2x Render patches. · Spot priming of bare surfaces. · finish coats to all nominated surfaces. · Clean-up upon completion of works.

Needing workers to help with Hebel, Render and foam for new houses being built

Cement render garden wall 12 mt x1 mt

I have a small wall at the front of the house that has a garden bed behind it. I would like to have it rendered flat so I can mount signage on it and it will look neat.

Need this wall rendered front, top and maybe 100-200mm on the inside. 7.7m long x 3 courses high.

I need an experienced handyman, painter, or maintenance tradie to complete two exterior repair tasks at my property: repairing a crumbling concrete/render section beneath a front door threshold, and prepping/painting a weathered timber window sill.

Looking for someone to patch up this render holes and failed patching job

Minor rendering patch on a garage wall- see photo attached.

Exterior corner of house has developed a crack and separation near the eaves/fascia. Looking for someone to repair the damaged section. May involve render, timber trim, or fascia repair if possible please inspect and provide a quote. Thanks More details: A trim board/cover on the exterior corner of my house is missing(circled in red), leaving the edge of the eave/soffit exposed. The matching trim is still present on the adjacent side( circled in green). need the missing section supplied, installe. Please inspect the area and advise if any additional repairs are required. Also in the photo with a single red circle, I would like the crack to be patched. In the last photo the section marked in blue appears to allow water ingress during heavy rain. I’ve noticed water seeping through this area, which may have caused the discolouration in the area marked in red. The second last photo shows the same area (yellow section from the first photo), but taken from the first floor. In this section, there appears to be a gap in the blue area where water may be entering. Could you please also check this area and advise if it needs sealing (e.g. sealant or waterproofing), along with the other repairs? Thanks This is a 2 storey townhouse

Needing a qualified renderer to help out for a day or two. Must have own tools and attention to detail is a must as it’s high end work.

We have external rendering work that needs to be done asap, we have painters at the house and want some external work done

Need a block wall rendered, wall is approximately 9 meters long by 2 meters high and I need both sides done.

Need two holes drilled into a rendered wall to install a small bathroom cabinet

I have had some renovations done and have patches of exposed brick which need to be rendered.

Base coat pillars and beams - supply render - base coat only Angle beads installed already