Find professional local plasterers in Parkdale

Plaster patching, finishing and sanding of various size holes, most are from previous electrical switches. Job needs to be completed by Wednesday 3rd December ready for painting and tiling Job is in Parkdale 3195

Various patching required for kitchen/laundry renovation, as well as amending 1 bulkhead and exterior angles. Pricing reflects 8 hours of work. Must be an experienced plaster. Job must be completed on Monday 24th/Tuesday 25th November.

We have 10x air vents which were previously used for our air conditioning unit, we changed to a split system when now uses heating and cooling through floor vents so we want to seal the ceiling vents across the house which are about 40cm squared. Need an experienced plasterer to help seal these vents up so that it is all level again. We have temporarily covered these vents with just a plastic cover screwed into the vent.

Need this one wall trowelled (based and topped). all done in the one visit. no sanding required. one wall, 9m x 3m. no internals, externals, squareset or cornices. just tape the joins and trowel. i have a bag of base and a bucket of top coat. want it done saturday

Primarily just brining plaster wall sheets and repairs to finish No sheeting required Just x2 base and a top coat finish to paint X1 exit corner and about 4m of cornice (I have)

Need this wall re gibbed and plastered. Happy to keep the top third in place if you can make it flush

I started removing the wallpaper from the main bedroom. There are 3 walls: 2 with doorways to hall / ensuite, 1 with large window, that has wallpaper partially removed. The walls will require patching / plastering before being repainted. Can you please quote for the entire job, measurements can be provided if required.

Plastering two holes in ceiling and a few small ones inside wardrobes

I tried to patch and paint 2 small areas of plaster in a bathroom, and stuffed it up! Need help to fix!

3 small holes / indentations need patching up. Photos attached

Including taking off old plaster shaft, framing and plastering the new Veux skylight shaft, approx 879x1200mm at 1000mm high. Easy access

Plaster - 2 wall areas around window/door(s) - 2 inner doorway surrounds - 1 hole in wall

Hi, We need an experienced plasterer who could do the following: 1. Carefully cut out the plasterboard at the bottom of our air conditioning housing. 2. Give us approximately a week to insulate everything inside the housing. 3. Come back and replaster the opening to make it ready for painting. Please refer to the photos. The area needing to be cut out is marked with read lines. Approximate size of the housing is 4900mm x 700mm.

bathroom that needs plastering in Parkdale, it’s roughly 3.2x1.1 with 2.4 high walls and a ceiling that needs to be replaced, alls square set with full height tiles so won’t need a super fine finish, need done asap

We recently had electrician replace chandeliers in both our lounge and dining rooms with down-lights. In both rooms the spot where the chandeliers used to be are now in need of repair. The job would involve repair/plastering the area - no need to worry about painting.

I have a bulk head over a range hood which has dropped causing damage to the cornices. I require someone to re secure the bulk head and fix the plastering. Please refer to photos.

Plastering joints for garage conversion walls and ceiling. Approx 4 m* 4 m with 2.2m ceiling heights.

Plaster sheets are in already, just need a plasterer to come and complete the job so we can paint the area. We added in a sliding door to an open living room as you will see from the photos

We want to make some changes to our existing carport, after the plaster ceiling fell down. We want to replaster cathedral style, leaving exposed trusses. We are also wanting to reduce the amount of timber up there. Wanting a carpenter to review the structure, hopefully removing some of the lower hanging beams, maybe reinforcing the trusses higher up. To ultimately have more height before any woodwork. Potentially even removing the front and rear facades, so it is just the frame and roof left. Like the steel framed example in the images. I know it can never be exactly like this, but as close to. There is quite a lot of timber, hoping some can be (re)moved. The roof is corrigated sheets, so not much weight up there. Apologies if this is a criminally low ball offer, let me know Looking for prices for any of these steps: - Reworking the trusses - Plastering cathedral style - Sanding and painting the exposed timber and new ceiling. Thanks Matt

Small hole in roof need plastering