Find a professional gyprocker contractor in Sydney

I would like to get 3 ceiling fans (remotely operated with lights) installed where oysters lights are currently installed, all gyprock .One power point is lose in gyprock, needs repair/replacement. One light switch needs to be moved by about 40cm to a different position in wall.

Need to mound a 42 inch on a gyprock wall, I have purchased the Wall mount from bunnings

I have a damaged gyprock wall around a service shaft in a bathroom that needs to be repaired. Using aqua check as it’s in a bathroom

Looking for someone to: - remove the gyprock partition and architrave as pictured (waste can be left on site) - patch the rear wall as required where the partition was, and sand ready for painting (do not need to paint) - patch the ceiling where the exhaust fan is and sand ready for painting (do not need to paint) - install new floor tiles where the partition was. Spare matching tiles supplied. This part of the room is not waterproofed. Waste can be left outside as a skip bin for other work will be ordered in a few weeks. Many thanks.

We need an experienced mirror/glass installer to cut and install 3 large mirrors at our physiotherapy clinic. Each mirror already has the Z-clip attached, but we do not have the wall-mount brackets, so you will need to supply and install the matching brackets. Mirror details: • 3 × mirrors — 3015mm × 709mm, approx. 5mm thick • Mirrors already onsite (no pickup needed) • Installed using Z clips – top clip load-bearing, lower clips to keep mirror flat • Manufacturer measurements for clip heights and spacing provided Installation surfaces: • 1 × brick section • 2 × gyprock sections Installer must supply correct fixings for both. Scope of work: • Supply matching Z-clip wall brackets • Measure and cut mirrors if required • Install brackets at correct heights • Hang all mirrors flush, level, and secure • Ensure minimal bowing using additional clips Manufacturer notes: • Mirrors sit 5mm off the floor • Clips #2 and #4 are non-load-bearing (prevent bowing) • Diagrams of clip positions available Location: Strength and Pilates Physiotherapy G 103 Foveaux Street, Surry Hills (ground floor) Requirements: • Experience installing large gym/studio mirrors • Own tools, brackets, fixings, adhesive if needed • Ability to cut mirror cleanly • Professional finish essential

The removal of a burn mark on the kitchen bench and would like the surface restored back to its original color.

Need to do a full ceiling and wall. Commercial job, need to get pricing for it. Job starts soon.

Gyprock repair - patch damage with a filler or topping compound and sand smooth and then painting the area to match the rest of the wall.

There is a large hole behind the door, in the gyprock wall. Wall needs repair. Also, another very small area needing patching. To prevent damage in other rooms, needing 3 door stoppers attached to the walls.

Need a gyprocker to remove existing and replace gyprock at one sides of my skylight in the corridor. Must be painted after replacement

Hi, I need an experienced dry waller to install drywall over some exposed bricks in a home. The drywall will need to be in line with the existing drywall on the lower third of each surface and finished ready for painting. The images below indicate the job areas. I have not yet settled on the property but can arrange for the real estate agent to walk you through the site and adjust quote accordingly. Thanks.

Hi, I’ve just demolished an internal wall and now need a gyprocker or plasterer to: • Patch and repair wall and ceiling gaps • Re-sheet and flush joins • Sand and prepare for painting There are some areas with exposed brick and framing that need neat finishing. I can send through photos for reference. Please let me know your availability, quote, and if you can come by this week for an inspection. Location: hillsdale

After changing the location of our ceiling fans we have a small hole in the gyprock ceiling from a previous install. Wish to have this patched and fixed up. The hole is about 4 inches or less wide.

Remove non-weight-bearing wall and build a new section of wall (gyprock) and remove one built in wardrobe and one cabinet.

We need to have a 2.1m half wall plaster repaired at the edges and raised by about 5 cm, so it lines up with our kitchen cabinets for the upcoming stone benchtop installation

I’m planning a renovation and need new gyprock installed for the lounge room and kitchen, including both walls and ceiling. Could you please provide a quote and brief outline of what’s included? What ill need itemised quote (materials + labour) and any photos of similar work you’ve completed.

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

We need to install this table to a meeting room in the office. "The Wall Mounted Booth Table can be installed using a drill by itself, however, we recommend an experienced builder installs the restaurant table as you will need to ensure that the fixings are secured into solid timber in the wall. Each order comes with handy instructions too. " Length: 47.2″ (120 cm) Width: 27.6″ (70 cm)

1. Cut gyprcok wall (direct stuck to block wall) 2. Install 10 angles (needs to be level for 2x shelves) 3. Re-plaster around angles / set and sand ready for paint. Only materials supplied will be angles, fixings for angles and plasterboard.