Find a professional gyprocker contractor in Sydney

Jobs 1 and 2 are simple. Fill the holes with plaster and then paint over. Job 3 is more complex. Cut out the gyprock (may be fire rated gyprock, am not sure), replace-gyprock that square, plaster and paint. We will provide paint. Other materials provided by you.

Fix holes in gyprock behind TV (2 x Power Points to be filled in) and some nail holes. Also one Large Power Point to be filled in and one small hole on a ceiling where a downlight use to be. All pretty small patches (4 small ones in total) plus some small nail holes. You provide the materials to complete the job.

Have just had my aircon upgraded and require a couple of small patch repairs done to the gyprock where they boys needed to cut through. One is self explanatory… the other requires either a vent that can be removed or some other small access door/flap (250x250mm) as the aircon pump for that system sits behind it.

I am trying to put a sauna in my gym, we have a space of 1200mm wide which fits the sauna perfectly. We need the existing cabinets disassembled and the skirting removed (skirting will go back on later so need to salvage) The actual space though narrows from 1200 at the opening to 1180 where the sauna needs to go. Wanting to shave off 10-15mm each side to fit the sauna.

Three holes in gyprock wall need repairing and painting . Holes are roughly 100mm squared . One rounded hole as pictured and two similar linear holes shown in other photo.

I need gyprock installed to the lower third of an exposed brick wall to prepare the wall for installation of wainscotting. The section of wall to be covered is 270*90cm You will need to include all materials in the quote.

Gyprock the ceiling of a re-roof

Need to drop ceiling 30cm I want new gyprock ceiling 100sqm beauty salon

Old leak fixed but never painted over, looks like gyprock ceiling

We removed sliding door wardrobes in two bedrooms and cut the gyprock 30 cm higher in one room and 20cm higher in the other room. We need the cut part of the wardrobes patched and plastered before the new ones get installed on 7 October. We will paint once you are finished.

Some holes and scratches in gyprock walls need to be repaired , nothing bigger than 100mm squared . we have the paint required for painting over after

I have done a lot of the gyprocking and have hit my limit. Need someone to come and finish the job. - all walls are double gyprocked with soundcheck - need someone to come finish the job in the inside + plus setting.

We have purchased a 32-inch Samsung Frame TV and wanting it to be mounted on existing gyprock wall in kitchen/dining area.

Repair/replace gyprock after kitchen sink and cabinet removal. Only need the gyprock replaced. Do not need taping or application of jointing compound

Need to move 1200 x 3000 gyprock sound check up some stair at an annoying angle. Need strong and professional.

I need a someone experienced in gyprock/plasterboard repairs to fix the 15cm hole in my ceiling so it blends seamlessly. Scope of Work • Cut and neaten hole edges • Install backing support if required • Fit a plasterboard patch • Tape and apply joint compound in layers • Sand smooth and finish flush with ceiling • Prime and paint to match existing ceiling colour Location: Haymarket • Ceiling is standard height • You will need to bring tools and materials • Paint needs to be colour matched

Approx 43 sq metres of ceiling and walls in Marrickville. Finished ready to be painted.

We need to install this table to a meeting room in the office. "The Wall Mounted Booth Table can be installed using a drill by itself, however, we recommend an experienced builder installs the restaurant table as you will need to ensure that the fixings are secured into solid timber in the wall. Each order comes with handy instructions too. " Length: 47.2″ (120 cm) Width: 27.6″ (70 cm)

1. Cut gyprcok wall (direct stuck to block wall) 2. Install 10 angles (needs to be level for 2x shelves) 3. Re-plaster around angles / set and sand ready for paint. Only materials supplied will be angles, fixings for angles and plasterboard.

Gyprocker to base and top coat two walls. 1st wall 4m long x 3.2 high. Wall will have a door in center 2nd wall 2m long x3.2 high Base coat and top coat on site No sanding Must be done on Friday.