Find professional window and door services in North East Melbourne

Supply and Install 2x internal doors including weather seals, automatic drop seal and a soft close latch Doors need to be solid core. First entrance - width is 0.824m, H 2.035m Second entrance - width is 0.770, H 2.043m

Needs to install brand new 13 indoor doors and 2 external doors. All the internal doors need privacy locks installed. The external doors need double locks. All doors, hinges and locks will be provided on site. Doors are standard doors with average width of 720mm-820mmx 2040mm. One external door is 870mm width with 2040 height.

Replace the door to something similar to this in the link. https://pin.it/3XGHXsN9n Replace with a A bi-fold door or folding door I did a measure inside the door trim, approx 2350 x 900.

The installation on aluminium Door.3 Handles of 600mm single side doors,and one automatic door closer

Need to install doors for two internal closets. The closets are not standard size so the doors (standard size from Bunnings) will need to be trimmed by 1cm each on the width. We need handles attached to the doors too. This needs to be done before 5 June.

Hi, I’m looking for someone to repair a damaged internal door in my rental property. The door has a hole/crack near the bottom and I’d like it repaired professionally so it looks neat and presentable again. Ideally looking for someone experienced with door repairs, patching, sanding. Budget: around $150. Located in Donnybrook. Please message with your quote and availability. 📸 Photo attached.

Dear Noah, we have a sliding door between the kitchen and our butlers kitchen that has become heavy and difficult to close.

Sliding door is very hard to open and gets stuck sometimes does not slide open smoothly like other door

The sliding door for our ensuite bathroom doesn't slide properly. Need someone to come fix it

Supply and install 2 towel rails in the bathroom, repair a leaking bathroom tap, and replace 2 door knobs (door knobs supplied).

Looking for handy man to fix stuck x2 sliding doors It gets stuck somewhere when trying to close the doors other than that the sliding door works fine

Two doors need re-hanging , one internal bathroom door and one door leading from laundry to outside. Both doors hang lopsided and grab the floor.

My Eco Garage door, won’t open, may need a reset

Water damaged toilet door repair or replacemnt

I’m looking for someone experienced to repair or replace the rollers on a sliding door that has become difficult to open and close. The door is sticking and not sliding smoothly along the track. What needs to be done: * Inspect sliding door and identify issue with rollers * Repair or replace worn/damaged rollers * Ensure door slides smoothly and aligns properly * Check and clean track if needed Location: [Your suburb here] Budget: Open to offers Preferred time: Flexible – ideally as soon as possible Additional notes: Please bring your own tools and any necessary replacement parts. Experience with sliding door repairs is preferred.

Toilet door is not closing. Looks like it needs to be taken off hinges and planed/refitted.

I need to instal a sliding door dog door. It’s a separate panel that attaches in the sliding door mechanism.

I have 6 door knobs (including hinges) that need to be replaced You will most likely need to notch out the door for the strike plates and potentially realign the doors to suit.

The sliding door to my laundry is not sliding along its track properly. The sliding doors on my linen press have come off their tracks, and the tracks are loose. Both sets of doors are timber.

7 new doors I will be supplying to be installed (old doors removed and hinges will fit old fit) Door hardware also supplied/hinges 4 hollow veneer internal doors 2 double glazed french external doors 1 primed timber with glass window external for garage A few doors just need minimal trimming in sides Anytime from 20th April I am being asked for photos - so included current/old, doors are the standard 82x204 and 72x204 - old doors are single core same as what is going in