Find an experienced door installer in Melbourne

We have a dog door (Hakuna Pets Super Tough Pet Door - Large) that we need installed. The glass will need to be replaced with toughened glass on one door. The size of the door is 2400 x 750, size of glass is roughly 2200 x 500.

I am looking for someone to install a dog door into a glass window. The glass will need to be cut.

We’re looking for a professional tradesperson to install glass walls, plaster partitions, and an entry door in an existing office located in Melbourne CBD. The exact area and measurements can only be confirmed after an on-site inspection. Please include in your quote: Labour and materials (if available) Estimated timeframe for completion Availability for site visit Experience with commercial office fit-outs will be highly regarded. 📍 Location: Melbourne CBD 📅 Inspection: Required before final quotation

Install door lock in bedroom and bathroom door

Hi, I am looking for a service to replace the 10 door handles. I have bought 10 new door handles sets. Wanted to set it done on or before 22 October 2025. Please refer to the photos attached. The silver door handle needs to be replaced with the black door handle set. Thank you.

LG washer door seal needs replacing

Install roof and door on an easy shed & fix to slab

6 doors that need door handles installed.

install a cat door in a wooden door

Reinstall door handle that has come apart have all the parts

We need a door frame and jams built to then install the door and lock we already have to close up access to the area -existing opening measurements are estimated at 1000x 2130 -door we have to be installed is 820x2040 -door handle and lock will also be supplied just need to be installed Need this done ASAP

Replacing door handles (approx 10 doors) New handles require the whole to be slightly bigger (sanding / shaving required) As you can see in pic - handle base doesn’t sit flush and sticks out slightly Can take all the handles off prior to save you time!

I want someone to come and fix the door and align the new hardware that I bought, I’ve already installed but they need abit of adjustments and install 3 door stops

Hi there! We have a door currently installed that we put on while we were living in our place so we could have a doggie door. We’re moving out now and just need someone to remove the current door and install the old one please. Just let me know if you have any questions at all :)

Need door handle with lock replaced. Need airtasker to provide new door handle.

Need to replace a door lock and install automatic door closer. Supply and install lock and door closer.

I need a Door Handle Replacement / Light Wood Filler Patch Up Job to clean up my Door, as the Door Handle has been ripped off completely & the Door itself is slightly damaged from where it was torn out.

We need someone to repair or replace a bathroom sliding/pocket door that has sustained water damage along the bottom section. The affected area is warped, peeling, and partially rotted. 🛠️ Scope of work may include: • Assess damage and advise if repair is possible or full door replacement is needed. • Repair the lower damaged portion (patch, fill, sand, repaint) OR • Supply and install a new door (if needed – we can pay extra for materials). • Ensure door slides smoothly and locks as normal after repair

Hi, I require either a carpenter, door installer, or locksmith to make an alteration to allow a latch to fit inside the strike hole again. The lock itself appears to work in that the key locks and unlocks the handle and latch of the lock, but the gate door won't ever lock. Looking closely, the latch doesn't sit inside the hole anymore and hits above it, due to a misalingment. When it was installed a couple years ago, it was working fine, however the door may have recenty shifted or warped, causing this, although I'm not sure. I am seeking someone to correct this, ideally by first checking the hinges and alingment of the door, etc. If this doesn't work, then perhaps remounting the strike plate higher or trimming off a bit of the metal at the top of the strke hole, or whatever you suggest. Best Regards, Mike

Install a microchip doggy door