Find an experienced gas fitter in North West Melbourne

We are renting our house out and need a routine gas check as compliance, we have a 3 bed town house. Need certificate to show real estate agent.

Fix the broken stud on centre gas burner . Stud provided. Just need to open the cooktop and fix the stud and reseal the cooktop. Nice and easy 20min job.

Got an old Vulcan wall gas heater that needs to be removed and gas capped. Need licensed gas plumber.

I'm looking for a licensed gasfitter to inspect and repair my gas cooktop. The large wok burner ignites when I press and hold the control knob, but as soon as I release the knob, the flame goes out. The other burners are working perfectly fine without any issues. I've attempted to clean the burner, which initially seemed to help, but unfortunately the problem persists. I suspect there may be an issue with the thermocouple (flame failure safety sensor), but I'd like a professional to diagnose the actual fault and carry out the necessary repairs. The freestanding oven is a Technica brand, usually a builder's choice.

Need a licensed plumber to re pipe gas pipe to stope top. Current copper pipe has been twisted. Pipe connections are 15mm and i presume the copper pipe is 1/2inch.

Hi, i have a Gasmate Appolo 6 bbq which needs to be connected to natural gas supply.

Hello, looking for a gas fitter to work with. Have more than 40 hours a week, but if you only available for less a week then that is fine. We pay weekly, and pay for travel and any other expenses you may have. Please put in half an hours rate of pay, i will choose someone to do a paid interview with. Also, we are aiming for a long term partnership. If you have any questions, please feel free to ask. Thanks!!

Cap a gas meter - possibly shift gas meter

I have a gas pipe on the wall but no water connection, need water and gas pipe connection for my new bbq set up.

Replacement of thermocouple and igniter. Gas stove cooktop, technika.

Can someone cap off the gas and remove the heater

Need a gas isolation switch / valve added to gas line by a licensed gas fitter. Certificate to be provided.

We have a deck being built and need to relocate the gas meter 4.5 meters towards the road so they can read it. It’s being relocated with gas company on 15/10/26 at 7am.so will need gas/plumber there at that time. I can dig the trench prior but will need to know plumber/gas requirements . In the photo, where the tape measure is where we need the meter relocated tototo .

One gas burner does not light via ignition. Rest are working fine.

Gas leak identified by insurance in report. Need to find if it is because of malicious damage

I am setting up a BBQ machine in my alfresco..I need the Beef Eater 1200 series 4 burner gas BBQ machine connected to an existing gas supply point.

One of my gas stoves ignition pin is broken & needs to be replaced.

Existing connection to water, drain and gas exist in the alfresco. Need someones assistance with connecting sink, single burner stove and beef water bbq 1200 series.

I have a Blanco gas cooktop where two of the burners ignite normally and produce a strong blue flame while I’m holding the control knob in. However, as soon as I release the knob, the flame goes out. The other burners are working normally. I suspect the thermocouple/flame-failure device may need cleaning, adjustment or replacement. Looking for a licensed gas fitter/appliance technician to diagnose and repair the issue. Thank you!