Find trusted local electricians in North East Melbourne

Legislated safety checks for gas and electrical by a certified electrician who will be able to provide the certificates as per current legislation for rental properties

I need help to changing two downlingts. One in the kitchen and bed rooms with low cost. $100 for both.

NBN, Data Cabling & Power Points – Residential Install I am seeking a qualified ACMA-registered cabler and licensed electrician (or suitably qualified contractor) to supply and install structured data cabling, NBN location setup, Wi-Fi preparation, and new power points in a residential property. 1. NBN Location • Install internal NBN NTD in the Family / Meals area, on the internal wall near the kitchen. • Location chosen for central coverage and convenient access for modem/router and mesh Wi-Fi system. 2. Compliance Requirements • All data cabling must be installed by an ACMA-registered cabler • All electrical works must comply with AS/NZS standards • Contractor to supply relevant compliance certification where required • Workmanship to be neat (concealed cabling where possible)

Require two exposed mains cable to be protected by conduit (orange). One fuse box runs the neighbours property

Require two exposed mains cable to be protected by conduit (orange). One cable needs to be move slightly in switchboard and exit through temp post. Would possibly like to have a supplied flood light run in conduit also and attached to tree. Ideally have a sensor where it only comes on at night only. If too much I’ll just run it off a timer. Switchboard already has two GPO’s

I have a broken light fitting in my spa that I need help replacing or removing. I tried removing the light, but I broke the entire fitting. I am unsure if I can find a replacment, or if I need someone to remove the electrical components for the light altogether.

I need an Ethernet port installed from my NBN box in my garage to my downstairs living room. There are existing Ethernet ports located upstairs. Double storey house.

Air conditioner repair..water leaking from the indoor unit

Downlight not working, new globe

I am looking for qualified sparky to install two wired smoke alarms and provide certificate

Repair x1 Ac outlet Install approx50cm conduit through masonry/wood

I am looking to get the following tasks done: 1. Install outdoor lights x 2. The electrical connections are ready. 2. Install Pendent Lights x 3. The pendent lights are all assembled and ready to be fit to the ceiling. The ceiling also has electrical connections ready. 3. Connect TV Cables from the roof space to the Opticomm box located in the garage using a splitter. Must be a licensed electrician. I am located in Wollert, VIC, and I flexible with date and time.

Repair damaged plaster in the ceiling and reconnect the light fitting to a mounting point so it does not fall off again. Paint if needed.

There are 2 LED downlights that have stopped working. One of them quit over 12 months ago but still had sufficient light. However the second one died recently so both need attention. Could be the driver as one of them occasionally turns on again.

Hi there 👋 I had an NBN fibre upgrade appointment, but the technician couldn’t complete the installation because I wanted the indoor NBN connection box/modem installed in my closet (where my current setup is). He said he couldn’t use the existing cable path as it runs inside the brick facade, and therefore couldn’t get a new fibre through to that point. He also didn’t install the outdoor unit for the same reason. He advised me to get a licensed electrician/data cabler to: Create a new cable path or conduit from outside (where NBN will mount the outdoor unit) to the closet where I want the modem. Ensure the cable route is ready for NBN to return and complete the fibre connection. Job details: Single-storey brick home 🏡 Need neat, NBN-compliant cabling or conduit installed Easy access to both outdoor wall and closet Just need the cable path ready — NBN will handle the fibre install once this part is done Timing: Flexible — weekday or weekend is fine. Please quote only if you’re a licensed cabler or electrician experienced with NBN fibre or data cabling. I have attached pics of existing connection from outdoor unit to indoor modem in my closet

Remove two existing light fittings and replace them with new fittings, which I have already. Must have licence and insurance.

Supply and replace power point

There are about 4 electrical plug points to be repaired. Nothing wrong with the physical plug. They just don’t work.

Rough in 12 downlights and four switches 4 in bedroom (1 switch) 6 in open living (2 switches) 1 to operate kitchen and 1 to operate living. 2 in bathroom (1switch) I have cable on site

This is for a customer of ours who purchased a lamp but upon opening the plug had been detached. We require an honest, reliable and professional sparky to complete an onsite repair of the plug to Australian safety standards and leave the lamp working for our customer. Job needs to be completed this week, any day between approximately 11-2pm. Estimated time to complete the task, 1hr max. An easy simple task that we need help to resolve as it’s interstate from our warehouse. I can share additional videos and specs of the lamp so you will be prepared on arrival. Have added a buffer so Parts to be included in the task budget. We’ve had this completed before by a local sparky who re wired the whole lamp and added a dimmer and the total cost was $150. This the same budget allocated for this simpler repair. Parts needed: Option 1: white Australian plug (Assuming it can be rewired directly where the other one came off and that’s all that is needed) Option 2: complete re wire, 2.5m white cord, with white foot plug closer to socket. Thank you!