Find a trusted local electrician in Bellevue Hill

I need my electric MURF bike built, doesn’t look very complicated, but I just don’t have the time The bike is in my garage and lots of street parking available - Due date: Needs to be done on Sunday, 4 June 2023

I have purchased a MURF electric bike and it looks like it needs basic assembly. Thank you - Due date: Needs to be done on Saturday, 20 May 2023

Electrolux Dryer spinning but not drying. Filters are clean. - Due date: Needs to be done on Saturday, 13 May 2023

Electric gate partially opening and then closing quickly. - Due date: Before Monday, 17 April 2023

I think an external light getting wet from house pressure cleaning has caused with safety switch to activate and I can’t get it back on, resulting in some lights in the house not working. Help! - Due date: Before Wednesday, 8 March 2023

The electrical fuse (15A) blowns because of a poor power converter. The 15A fuse needs to be replaced (not the thermal ones) Japanese Model Zojirushi NW-US07-BZ - Due date: Flexible

Hi - I need an electrician fir these jobs pls: 1. Install bathroom fan in wall vent above bath -can run power from light (see pic - you can see both the light location and wall vent) 2. Update switchboard to accommodate fan /light connection. RCB.see pic of switchboard 3. Remove heated Towel rail (see pic) 4. Move PowerPoint behind fridge up about 40cm - it’s about 160cm off floor now. Pleas let me know- Thank you Mark - Due date: Before Saturday, 11 March 2023

Pressed the RCD test button, but now won’t reset - Due date: Needs to be done on Sunday, 12 February 2023

Electrician needed to fix lights - something tripped and now none of the lights work - Due date: Needs to be done on Wednesday, 7 December 2022

I have a campervan that has been set up with a Lithium battery. There is a voltmeter that usually displays the voltage, plus has USB ports. The voltmeter display has stopped working, as have the USB ports. I would like somebody to help make the voltmeter display and USB ports work again. Note - pictured is the voltmeter working. This is currently not working. - Due date: Before Friday, 2 December 2022

Power point in kitchen has died ( needs replacing), plus check a few of the points - Due date: Flexible

I have a new Tail light for my motorbike that doesn't fit the existing connection. I need the wires spliced together so the light is operational. Very easy access to the wiring as per photos.

Dishwasher make: Asko Issue: When turned on it trips the electricity board immediately when dishwasher turned on (Electrician says someone who specialises in dishwashers is recommended) Due - ASAP apart from Saturdays. Thank you :)

Need a locksmith to replace an electric door strike - Due date: Needs to be done on Tuesday, 9 August 2022

Standard Lamp suddenly stopped working when bumped by grandchild. Bulb fine. Wiring looks robust. Switch may have failed. If switch cannot be replaced I have the power point switched on the wall so the switch on the lamp could be bypassed. - Due date: Flexible

Electrician needed to repair / install new transformers for 4 garden lights

Hi there - I’d like an electrician to come round and install 6 electricity outlets. Pictures of where I’d like them installed and closest existing points are attached. Most of the walls are brick I believe. - 2 new outlets in each bedroom - 1 new outlet in lounge - 1 new outlet in bathroom cabinet Thanks - Due date: Before Friday, 29 July 2022

The electric strike at my back gate is in a permanently released position. It is powered by two cables as shown. There is power to the external key pad that releases it. I believe the internal release button shown below may be corroded by teh recent weather. The task is to diagnose the problem and repair it. The quote is for a site visit and 2 hours work. I will pay $100/hr for extra work and I will pay for the cost of a new release button and striker system if these need to be replaced - Due date: Flexible

Striker plate fitting has come loose. It is cemented/blogged into sandstone. It now no longer aligns with teh snub in teh gate - it has dropped - and it is loose. needs to be placed firmly back in place and strike plate electrics checked. I have another identical gate where the release is permanently open. The electric connection to the release button needs to be checked - Due date: Flexible

I have the replacement lights already, so just need someone to switch them all over. Replacing: 4x bedroom pendant 2x hallway pendant 1x ceiling light in bathroom 2x wall lights 1x ceiling batten in kitchen Ladder needed (or you can use ours if needed)