Find trusted local electricians in North East Melbourne

Need 10 downlights installed

I’m looking for a licensed electrician to carry out the following electrical works at a residential property: Scope of Work • Install one new double power point (location to be discussed onsite) • Run a new high-capacity cable from the main switchboard to the new power point • Install a separate dedicated circuit breaker (fuse) in the existing switchboard • Ensure all work is AS/NZS compliant • Test and commission the new circuit • Provide Certificate of Electrical Safety (COES) upon completion Property Details • Residential house • Switchboard is accessible • Power point location is approximately 5-8 metres from switchboard (happy to confirm onsite) Important Requirements • Must be a fully licensed electrician (VIC licensed if in Victoria) • Must provide license number with the offer • All materials, labour, testing, and certification to be included in the quote • Job can be done on a weekday or weekend (flexible)

Install Revel Sauna heater and light and wireless controls for sauna

Verify and Install Solar panel

I have 5 down lights globes blown that need replacing in the ceiling. It will be a supply and fit job please.

I have a customer who spilt a bottle of Rice Wine Vinegar in cupboard that leaked through to the rangehood below. The result is that the rangehoodno longer fully functions as the switches (control board) was effected. The control board still lights up an LED and the fan turns on to a low setting when the unit is switched on at the PP. No other buttons work!

Inside glass pane on bar fridge door has shattered and needs replacing. Approx 40 X 80cm. Fridge brand is Chillmax

We need the following; 1. Security camera/spotlight installed on corner of eaves (2.8m off ground) - connects to wifi 2. Internal light switch moved from one side of the wall onto the the other side of wall 3. Lamp connector fixed 4. Light switch changed to single switch (currently double)

Repair x1 Ac outlet Install approx50cm conduit through masonry/wood

Repair damaged plaster in the ceiling and reconnect the light fitting to a mounting point so it does not fall off again. Paint if needed.

There are 2 LED downlights that have stopped working. One of them quit over 12 months ago but still had sufficient light. However the second one died recently so both need attention. Could be the driver as one of them occasionally turns on again.

Hi there 👋 I had an NBN fibre upgrade appointment, but the technician couldn’t complete the installation because I wanted the indoor NBN connection box/modem installed in my closet (where my current setup is). He said he couldn’t use the existing cable path as it runs inside the brick facade, and therefore couldn’t get a new fibre through to that point. He also didn’t install the outdoor unit for the same reason. He advised me to get a licensed electrician/data cabler to: Create a new cable path or conduit from outside (where NBN will mount the outdoor unit) to the closet where I want the modem. Ensure the cable route is ready for NBN to return and complete the fibre connection. Job details: Single-storey brick home 🏡 Need neat, NBN-compliant cabling or conduit installed Easy access to both outdoor wall and closet Just need the cable path ready — NBN will handle the fibre install once this part is done Timing: Flexible — weekday or weekend is fine. Please quote only if you’re a licensed cabler or electrician experienced with NBN fibre or data cabling. I have attached pics of existing connection from outdoor unit to indoor modem in my closet

Remove two existing light fittings and replace them with new fittings, which I have already. Must have licence and insurance.

Supply and replace power point

There are about 4 electrical plug points to be repaired. Nothing wrong with the physical plug. They just don’t work.

Rough in 12 downlights and four switches 4 in bedroom (1 switch) 6 in open living (2 switches) 1 to operate kitchen and 1 to operate living. 2 in bathroom (1switch) I have cable on site

This is for a customer of ours who purchased a lamp but upon opening the plug had been detached. We require an honest, reliable and professional sparky to complete an onsite repair of the plug to Australian safety standards and leave the lamp working for our customer. Job needs to be completed this week, any day between approximately 11-2pm. Estimated time to complete the task, 1hr max. An easy simple task that we need help to resolve as it’s interstate from our warehouse. I can share additional videos and specs of the lamp so you will be prepared on arrival. Have added a buffer so Parts to be included in the task budget. We’ve had this completed before by a local sparky who re wired the whole lamp and added a dimmer and the total cost was $150. This the same budget allocated for this simpler repair. Parts needed: Option 1: white Australian plug (Assuming it can be rewired directly where the other one came off and that’s all that is needed) Option 2: complete re wire, 2.5m white cord, with white foot plug closer to socket. Thank you!

Need an electrical safety check - Report, Residential Tenancies Regulations 2021 completed for a rental Property.

I need to run electrical power to the middle.of the courtyard to connect the fountain .

Looking for a qualified electrician to install two pendant lights above my kitchen bench.