Find trusted local electricians in Mornington Peninsula

My aircon is not working and I’m having op on Tuesday so would like it working . It has lights on but not working and Ive put new batteries in remote

Moving power points about 20 cm away from their existing location on both sides of the room.

I need to get a smart meter installed in a Redback battery system

Install a Panasonic Split System

I need a double power point installed in my bedroom. The nearest power point is on the other side of the room (opposite wall). Single story unit, brick exterior. I will need an electrical certificate for the work. Any further info required, please message me 😊 price is negotiable. Thanks in advance!

I need an experienced tradesperson to correctly prepare existing electrical conduits that currently sit on top of the crushed rock base, so the area is ready for concrete pouring. Works required: • Carefully lift and lower existing PVC electrical conduits so they sit below the finished concrete slab level • Provide proper sand or fine crusher dust bedding under the conduits (no sharp aggregate) • Ensure minimum 50–75mm clearance below the concrete slab • Cover conduits with sand (minimum 50mm) before re-instating crushed rock • Re-level and compact the crushed rock base to a clean, even finish suitable for concreting • Ensure conduits are protected from crushing and movement (sleeving if required) Important notes: • This is a driveway slab area and will carry vehicle loads • Conduits must not be visible at finished base level • Work must comply with standard pre-concrete construction practice • Area must be ready for immediate concrete pour once complete

Electrician needed for installing the The Norge 4-Person Stillhet Hybrid we assumed three-phase power responsibility

Our modem power cord has burnt out a power outlet causing an outage to some power points in the house. Need this examined and power point replaced. Also have a rake ceiling light fitting to be installed:

I took about a vintage doll and accidentally pulled some of the wires out of the circuit. It was functioning prior to this so I know it works. Pretty sure where most of them go but it’s not my field obviously. Happy to drop off/pickup from anywhere around Melbourne

I require someone to repair my Atari Lynx II. It currently doesn't stay on with the power plugged in as there seems to be a disconnect or something loose. If I hold it together, it works, but it should not be that way of course.

Preset sure a fuse needs replacing. Rangehood & outside lights not working need fixing asap

Hello. I require a reliable person to attend my property and check whether the smoke alarm is functioning correctly and issuing a letter / certificate. This includes testing the alarm and advising if the battery requires replacement or if the unit appears faulty. Battery replacement (if needed) may be quoted upon inspection. House : 3 BR 2 BATH in Capel Sound

Need a quote to add a power point to outside of new house, run underground cord to power in ground water tank pump, disconnect old house.

1. Remove old pendant light and replace with downlight to match with our existing downlights (pictured) 2. Install tv bracket and holes in wall for cords so we can put our tv on the wall. We have the bracket already.

I need two wall lights removed, and one new wall light put up half way between where the old ones were. I also need a ceiling light changed to just a batten fitting (have fitting) and a power point removed from the ceiling please. Easy ceiling access via pull down roof ladder.

Need 1 outdoor power point installing and also another in the eaves outside for a plug in ceiling speaker. Existing power is 1-2 metres away in both locations

Already install have to connect electric wire

I would like a power point where there currently is none so I can connect my printer. I think there is power because there is a light switch in the vicinity. Only thing I am concerned about is that the power is also close to the security alarm keypad, and I don’t want that to be restarted/impacted. House is single story. Colourbond roof. There is roof access through a small manhole.

Check the power output of this commercial property located in Frankston and provide me the outcome. Looking for Certified electrician providing reading of the power output.

A few small compliance fixes. REPLACEMENT OF NON-COMPLIANT RCD/RCBO - - MAIN ISOLATOR REPLACEMENT AT SUB-BOARD 1 FIRE CAULKING OF SWITCHBOARD & SUB-BOARD INSTALLATION 2 REPLACEMENT OF SWITCH - To disconnect faulty switch - To supply and install new switch Also 2 independent lights are not turning on so I assume there is a fault somewhere but no switches have been tripped.