Find trusted local electricians in Mount Martha

Looking for a licensed electrician to install a Tesla Wall Connector at our home in Mount Martha. The charger will be installed in the garage, immediately next to the electrical switchboard, so cable runs should be minimal. The job will involve: * Installing and connecting the Tesla Wall Connector * Supplying any required cabling, circuit protection and electrical materials * Testing and commissioning the charger * Providing the required electrical safety certificate We will supply the Tesla Wall Connector. Looking for someone experienced with EV charger installations who can complete the job safely and to Australian electrical standards.

The Hotwater circuit breaker is faulty and need replacement. I have the spare circuit breaker

There are two light fixtures one in the laundry and one in the toilet where the 3 mount that hold them in place are broken. Not sure what is a reasonable price

Install Anker Solix Smart Meter Main switch board single phase located inside car garage

Fault find, house trips, perhaps too many GPO's loaded onto 1 circuit? Need it checked out by REC. (May be more work work after this. Also, need someone experienced in installing electric cooktops too).

There is a faulty inverter in the house. Need to replace it with a new one for the solar to work.

Install Ikea chandelier. Existing light to be removed.

Replacing a power point and LED lights

Our pool heat pump doesn’t seem to be working. Temperature not increasing. Fan is not spinning. Need someone to check over and service it. It’s a Zodiac evaporative heat pump. We’re also looking to have two external AC units cleaned.

Install single drop pendant light in single storey house to right hand side of existing low voltage lights

I need to get a smart meter installed in a Redback battery system

I would like to install two linear lights as pictured - 1 x over the kitchen bench and 1 x over the dining table. This position already has points - there are 2 x points over the kitchen bench and 1 x point over the dining table Additionally, I would like to install 2 x pendant lights next to the bed as pictured. There are currently no points in this position. There are powerpoints at the base of the wall where the lights are intended to go

I need 1 pendent light installed in my house, also needs shortening

I would like a power point where there currently is none so I can connect my printer. I think there is power because there is a light switch in the vicinity. Only thing I am concerned about is that the power is also close to the security alarm keypad, and I don’t want that to be restarted/impacted. House is single story. Colourbond roof. There is roof access through a small manhole.

Moving house and would like our EV charger relocated to the new property. We would need the charger removed and safely capped off at the old property before it is relocated to the new property.

NBN technician is installing NBN fibre box in garage today. I need a power point to be installed and connect to the current cat6 cable. Old copper box has 2 data wires already pre wired. Electrician will need to bring cable to terminate to nbn.

4 power points in the kitchen (one in the island bench) and 3 lights (replacement in the pantry and two in the master bedroom

I would like a ceiling fan removed and an adjacent down light fitting reconnected.

New carport needs to be connected to power 10 metres away by running conduit from carport to side of house, installing 2 weatherproof power points

Replace kitchen bench lights , we have the new ones now.