Find trusted local electricians in North East Melbourne

We are hearing beeping sounds from the 2 smoke alarms and need to be serviced soon. The Model is Kiddie KA20-2 which is fairly new and was installed last year. Need a certified & licensed technician to service it as it is a compliance requirement.

Double story house installation of waterfall lights on upper level only and removed after event. Drawn in red on the second image where lights to be installed Lights will be provided

I have a 5-year-old solar system installed on heavy terracotta tiles. On cold nights between 10 PM and 2 AM, thermal contraction causes loud structural bang in the roof cavity. I need a technician to inspect the array, check that the mid/end clamps aren't over-torqued, and ensure the tile hooks have proper clearance so the metal isn't violently snapping against the wood or tiles. While you’re at it, check to make sure the installation was done correctly.

Two HomeGuard mains-powered smoke alarms (will supply them) to be installed. One on the ground level ceiling and one first floor ceiling of a townhouse. Wiring provisions already installed just need to plug the smoke alarms to the wires.

Hi I need , electrician for CEF certificate for my house at Donnybrook , I think it’s for electricity safe requirements! As the house has been without power for quite period of time

I have a new electric oven arriving today before 12pm. I'm looking for an electrician to remove the old electric oven and replace it with the new oven. The sizing and make is like for like. Disposal of the old oven too.

Looking for a qualified and licensed electrician to supply and install LED downlights in place of single central ceiling light fixtures across our home. Total 25-30 across all rooms Scope of Work: Remove central ceiling lights/batten holders and wire in LED downlights. Cut ceiling openings, route wiring, and connect to existing wall switches. Install dimmers or updated switch plates if needed. Ensure all work is compliant and safe, providing a Certificate of Electrical Safety upon completion. Certified electrician who could provide proper certification Max $50 per down light including labour cost

Electricity is tripping appliances in half the house - appliances have been tested and seem fine. The fuse switch that is down when this happens seems loose/ faulty. Need someone to supply and change.

We need to disconnect a power point permanently and make the wiring safe. There's no need to leave ready for plastering, blank plate, etc just disconnect and make wiring safe.

Need to remove old light fittings and install 4 new pendant lights. Wiring is already there.

Looking for a handyman to help with the following jobs: - Install a new power point - Install a bathroom basin set - Replace/install two door handles I’m flexible with the day and time and can accommodate any availability this week Thanks!

Swap out light fixture above dining room table. Current is a basic wooden shade, updating to a pendant.

We are seeking a qualified electrician to supply and replace 3 smoke alarms. Teeters been in the house since we purchased it about 12 years ago - looking to replace with new ones .

Looking for a licensed electrician to fix flickering GU10 downlight. The circuit has 6 LED downlights. One particular downlight socket/fitting seem to have an issue: * When an LED globe is installed in this socket, only 3 of the 6 LED elements within that individual globe illuminate or it flickers. * I tested the same LED globe in another socket and all 6 LED elements illuminate normally, so the globe itself appears to be working correctly. * The other downlights are generally working. I suspect there may be an issue with the GU10 socket/lampholder, connection or wiring, but would like a licensed electrician to diagnose the actual cause. Licensed electrician only. Please advise whether your offer includes call-out, labour and basic replacement parts.

I have 5 MR16 LED downlights. The globes are new, but the lights still turn on and off. I need a licensed electrician to replace the 5 transformers with LED-compatible 12V transformers and make sure all lights are working properly.

I want certified electrician to install two pendant lights for my Island bench in existing Wired battern holders by builder. Not sure if there is pre existing enforcement. Please check picture of the conical pendant lights to be installed. please also have a look the type of pendant lights.

LICENSED ELECTRICIAN REQUIRED - Vic A-grade licence + REC number (to issue a Certificate of Electrical Safety). Install only - Tesla Gen 3 Wall Connector (single phase, 7.3m cable) supplied by me. You supply materials + labour. THE JOB Double-storey, Wollert. Single phase, main switch believed 50A, rooftop solar. Switchboard is on the LEFT of the house from the street, garage on the RIGHT - so it's an up-and-over run through the roof space, approx 30-35m. Route: up the switchboard side in conduit, into the roof space (dektite), across the ceiling, into the garage ceiling space, then DOWN INSIDE the stud cavity of the right-hand garage wall, emerging behind the charger. ROOF ACCESS No manhole in the garage. Roof is tiles. FINISH - THIS MATTERS MOST No visible conduit or cable anywhere in the garage. Left and rear walls are exposed brick - not to be used. The right-hand wall is plasterboard-lined and is the only one to use. Cable concealed in the ceiling space and dropped inside the wall cavity, not surface-run down the wall face. Charger fixed to studs or backing plate, approx 1.2m off floor. SCOPE - Dedicated 32A single phase circuit, Type A RCD/RCBO to AS/NZS 3000 - Max demand calc, charge rate set accordingly (50A main may mean ~25A) - Isolation switch (I'd prefer it at the switchboard end) - Mount, connect, test, commission via Tesla app (2.4GHz Wi-Fi on site) IN YOUR OFFER - A-grade licence no., REC no., public liability insurance - Cable size + total run length as a FIXED price, not "up to X metres", and whether ceiling insulation changes it - If you must cut the plaster to fish the cable: who patches, is paint included - Workmanship warranty period Timing flexible. Photos attached. Quoted by four EV installers already - I want someone who'll commit to the concealed finish, not just get power to the wall.

Hi, I’d like to request quote for double-storey house: * Clean 20 solar panels * Clean the roof gutters * Install pigeon/bird mesh around the solar panels to prevent pigeons from nesting underneath * Please include removal of any existing nesting material/debris around the panels * Check and secure the mesh properly around all accessible sides of the solar panel system Could you please provide a total quote including labour, materials, cleaning and GST? Please also let me know if you offer any warranty on the pigeon mesh installation. The property is a double-storey house, so please include any additional equipment/access costs in the quote. Thanks.

Hang chandelier within new ceiling rose. Hole must be drilled first into ceiling rose and secured in roof beam. Must be fully qualified electrician.