Find trusted local electricians in Auburn VIC

Old flat, standard height ceiling. Two living room ceiling lights and two bedroom ceiling lights. Assess one other light for safety. Plenty of street parking. Flexible timing, super early or evening is ok.

Need to remove 5 pendant lights in Victorian home and replace with new pendant lights (which we have ready). Need to saw 20ml of length of rods on each light.

I would like a chimney fan installed in place of the existing cowl and then have the fan wired to mains and the control point installed into a wall or onto brick inside - photos will help you understand what is required The fan weighs approximately 20kgs. Roof access incredibly easy. I think wiring just requires conduit down the side of the house and wiring inside. Once I know what prices are and whether someone can do the work required I’ll order the fan.

My 3 phase power swit h keeps turning off

Removal of outdoor electrical unit connected to side fence. This fence will be removed after.

Job Description: Looking for a qualified handyman or electrician to reconnect a loose wire to a power point. It’s a small, straightforward job – perfect if you’re in the area and want to make a quick $100.

Electrical wires connected to the garage was cut off, looking for an electrician to splice it back to a power source to start up the garage again.

I need to install a 3 phase power outlet in my garage to charge the electric car. The main power box is located in the garage too.

Just to add additional lighting point and power point l. Propertys plaster board is under renovation now. Looking to add the point before plastering n rendering

Looking for a quote to move NBN box (FTTP) from one room to another, about 6 metres.

I have 2 downbulb to replace easy however I’m recovering from injury but sensor light no longer works hence need quote I am located in Hawthorn East I’m not sure cost so Will choose

Require 1 downlight to be replaced on the kitchen ceiling. The light will be sourced.

Just to add additional lighting point and power point l. Propertys plaster board is under renovation now. Looking to add the point before plastering n rendering

2008 crafter long wheel base, battery only lasting 48 hours, a prepurchase test by a prospective purchaser showed 1. EGR cooling and piping disconnected 2. Issue with 12V-240V not powering up

Replace 2 downlights - Brand is Ledvance Led Eco 8w Tri Colour Downlight I already bought the replacement lights, you just have to put it. 1 in living room and 1 in bedroom. Need to bring your own ladder/steps

The plastic bayonet / batten holder to a ceiling light fitting has broken and needs replacing. The light and connection works perfectly, it just needs a new holder for the bulb. It should take a sparky no more than 5-10 minutes to fix. Parking is available and an invoice is not required.

Setting up an exterior power point in our house (for gate). Use existing gpo if possible from one of the rooms, about 3m from exterior wall.

We have an electric gate being installed and would like power to connected from the house through conduit to an electric gate motor. We would also like 2 x outdoor power points to be installed

Fuse keeps flicking up and shorts the dishwasher

Fit off -4 circuits in switchboard, 10 GPOs, hws and 1 External 20amp isolator for aircon. Power points supplied by owner.