Hire an affordable Carpenter for any job in QLD

I have a kitchen island which is 900mm X 1200mm. I would like to replace the existing composite worktop with a hardwood, end grain butchers block of the same dimension. I wish the finished worktop to be approx 70mm thick. in the images attached i try to give a depiction of what i am looking for. I am happy if you deliver the worktop after only the first finish. I will do the fitting and final sand + seal I'll use this as a prototype and if it gains attention on social media then we can look to set up an arrangement for more fabrication work - Due date: Flexible

I have this awkward insert behind my front door. I'd like to make it into a storage box with a lid.

Ikea kitchen build. Cabinets are in place, we just need the more intricate final touches done by someone qualified! 4 x benchtops need cutting and fitting incl sink hole and a waterfall. Approx 3-4 side panels beside fridge etc, and roughly 5 small filler panels. Located Tarragindi.

I have just put together a Bunnings garden shed. I do not have the ability or tools to bolt into the slab. This is an urgent job as the shed is in position and needs to be secured.

Hey taskers! Would love a handy Andy to replace some fibre cement sheets please. New wardrobe going in and water damage found during demo. Just the one back wall inside cupboard no flooring needed. I don’t havr any materials. Has to be FC as backs onto wet area. 2438w 2436h Also need some plasterboard over a hole that goes right through the wall from one room to the other. About 50cm x 25cm Pics attached. Need done either this afternoon or tomorrow please in Palm Beach. Thanks!

Put together Small 1.5 m wide shed . Ground has been prepared . Should take 3-3.5 hour I understand . Bring your tools See pic

Hi, I have nearly finished my kitchen and am giving up on the tricky finishing bits. I need the integrated dishwasher door, cupboard handles and kickboards installed. All pieces are here at the job. I would prefer an hourly rate agreement and someone specifically experienced.

Deck requires resheeting. Approx 5*6m Location caloundra

End cover panel needs cutting and fixing to the cabinet

Transporting a timber (non slate) pool table from Sippy Downs to Warana

I bought a titan shed kit and decided to put it together myself. Probably a bit ambitious of me. The shed is 3m x 3m square. I need the rest completed. After someone with experience in shed building and roofing for a good quality finish. The frame is up. I need the gable walls sheeted, roofing, guttering and flashings installed.

have 2 new whirlybirds - Bradnam .. need installed on shed

Small scattered spots of hair dye stained into carpet after shaking the bottle without a lid in the ensuite bathroom. Approx 5 small spots, some darker than others. I'm in a rental so I need a professional cleaner or someone close to it. I know the stains can be removed and I have bicarbonate soda, vinegar etc for the job (one way to do it, there are others) If it's not a job for you please recommend any cleaning companies you think could tackle this because I'm too scared I'll ruin the carpet more 😅 I set the date but it can be done anytime required. I'm home 7 days most the day. Nights are also fine.

helping hand to remove existing framing then framing up ready for decking

Looking for someone to supply and install VJ panels to 2 bedrooms of my house. Ceiling height is approximately 2.4m and dimensions/configuration of the two bedrooms is in the photo. Note - we have been surveyed for asbestos and there is no asbestos in either of these rooms. Also worth noting - there is a doorway between the two rooms we want to have covered up. Painting is optional- we can do this ourselves if it’s not an option.

External:Remove old, supply & install new trim/frames. 1 door. 1 window. Door measurements: H:210cm W:97cm Trim width:6.5cm Window measurements: H:123cm W:180cm (3 foot 6) Trim width:7cm Job to be done in next couple of weeks before painter arrives.

Super quick and easy job in Tingalpa We need the laundry measured in investment property. Width x length (of full lundry room) Width back wall to laundry door (for appropriate depth base cabinet and bench top).

Need someone with experience to assist building a small Bunnings garden shed.

Hi all We have some engine oil stain spotting on our driveway that we really need sorted ASAP - stains are apx 3 months old and sporadic over apx a 1.5m x 1.5m space. Would then probably make sense to have whole driveway pressure cleaned so it doesn’t look weird. Driveway is a double behind roll-up door. Have tried various degreasers from bunnings, no luck so time to call in the pros. Can be completed anytime but hoping to do next week onwards, soonish. Located Burleigh Waters

In a new granny flat. See the pics for the plan. All pieces are on site and ready to go. Bench tops are maple. Require kitchen assembly. Require Bench tops installed. Require Two cutouts on bench tops. One for stove. One for sink. Fire away with your questions. Complete on any day of the week but ready to go. This has been reposted due to an accepted offer no longer in contact.