Hire a trusted stove installation and repair service in SA

Two of the burners are not working and need to be repaired.

I have a 4-burner gas stove/oven that needs to be disconnected safely, and removed.

Gas stove has not been used for awhile. Gas has also been recently reconnected

May be need to change igniter. Coz bosch 90cm gas cooktop PCT9A5B90A left-hand side one gas not sparking.

2 Larkhill Road, Elizabeth North, SA 5113 https://g.co/kgs/zsxKGQa Certificied electrician if possible Could you please replace this stove with Any Old Stove and oven ( if you have any) ? Old Stove is mentioned in this photo, and the address is given above. Could you please tell me how much it will cost? and when can you do this job ?

I'm currently installing a new kitchen in my brothers house and need to disconnect hid old oven and electric stove top. Everything's out in the open and easily accessible. Easy few minute job.

Old gas stove removed and brand new stove installed, both the same brand and 80 vm

I am looking for an experienced and qualified trade person to tirn off gas, remove an existing kitchen gas stovetop and install a new cooktop on a new benchtop. Price advertised is a placeholder

My gas stove is working with low flame

I currently have an old 60cm gas stove top and want to put in a 90cm one. I need someone to cut a whole in my laminex to fit a 900mm gas stove top Will also need it re connected to gas obviously. We installed a 900mm range hood a while ago. Thank you.

Gas stove key become hot when running

Gas stove key become hot when running

Gas stove key become hot when running.

We need to convert a single gas connection to a double for a oven and stove

Replace old gas/electric stove with new one 900mm

Looking to have someone remove our old standalone gas stove/oven and install a new one.

Old cook top has a small gas leak on one of the burners and needs to be removed and a new one installed. We are looking to redo the kitchen down the track, so it doesn't need to be flash, just safe and functional. To cooktops we are looking at to replace it are 600ml 4 burner. They will be shorter in width, but greater in depth than the current cut out. Therefore we will be looking to get a little more depth cutout of the wood/laminate countertop, and a plate that can cover the gap of the width as a short term solution until we can get the kitchen redone down the track. The pipe work below also appears to be a solid pipe, so it is likely a isolation valve will need to be installed. Measurements. Current: LxW = 975x445 Cutout depth: 405 Available depth for new cutout: 495 I will look to have the new gas cooktop ready. I don't have other materials but can look to have them ready upon request if needed.

Please see photos - Westinghouse is new unit purchased and the Platinum is the existing. Also attached photo of existing. Switchboard included. Thank you

We recently moved into a new home with a four-burner Euromaid gas stovetop, but three burners won’t ignite at all, and the fourth is extremely difficult to light. We suspect the ignition and spark components need replacing. We’re happy to source the necessary parts but need an experienced gas appliance technician or handyman to: • Diagnose the issue • Install new ignition/spark components (if needed) • Ensure all burners ignite and stay alight Looking for someone with experience in gas stove repairs. Please provide availability and a quote.

Need a qualified gas fiiter to install a gas stove - already assembled, just need to connect it to gas outlet. May need a regulator as well, not sure