Find professional local plasterers in Bondi Beach

Skim Coat & Wall Preparation – Bondi Beach Looking for an experienced handyman / plasterer to smooth and level an internal wall ready for painting. Wall Dimensions: * Approx. 92 cm wide high ceiling * Existing wall has uneven texture, old patch repairs and minor imperfections See photos Scope of Works: * Prepare wall surface * Fill and repair imperfections * Apply skim coat to entire wall * Sand smooth and leave paint-ready * Please include all materials and fees Please provide: * Quote * Estimated time required * Photos of similar work completed * Confirmation of experience with skim coating and wall restoration

Super quick job - my tools are in storage Just need one 8-10mm diameter hole drilled through an internal gyprock wall - so I can run a small hose through it (wall approx 75mm wide) Power point availalbe if your drill needs Easy access to house (park in driveway) You'll be in and out within 5-10 minutes

Professional wall plasterer to plaster internal rendered walls of old home. Walls have been prepared and all paint has been removed, ready to go. Can do anytime (day, night or weekends). Hourly rate with a minimum of 7+ hours of work available.

Ceiling and wall plastering needed. Ceiling: 3 x AC duct holes to be filled. Triple layered gyprock. Approx: 20cm x 180cm. Wall: Single layer gyprock. Approx: 200cm x 40cm.

Need to fix a little gyprock hole

Little gyprock hole. Need to fix it

Pretty simple job. Supply and fit one x or cut two x gyprock sheet/s to masonry wall no battens required as it will be a snug fit. No patching, no painting required. I have 1 x small tub of glue. Sheets can be fixed vertically or horizontally. 2625 x 1360mm h (1350 h ok)

I have a brick wall that I need plastering/plasterboarding (this 175*145cm approx) and also a hole in the ceiling as a result of a vent that needs plastering over so it can be painted

My roller blind was mounted to a timber plank, and the plank has pulled out of the concrete ceiling near the window. The blind and timber came down together. Needs someone to: • Inspect concrete ceiling and existing holes • Install proper masonry anchors / dynabolts into concrete • Secure a new timber batten or brackets correctly • Re-mount the blind safely so it won’t fall again • Patch/fill old holes and tidy finish • Check small gap/draft near window Photos attached. Please bring tools/materials or advise what’s needed. Happy to have inspection first if unsure.

I need my Samsung frame flatscreen hung on the wall today I do not have a bracket

We are looking to hang a round mirror onto a plasterboard wall. The mirror is not glass, but it has a metal frame so is heavier than something you might get at Ikea etc. Looking for someone who can hang it properly, using the appropriate fixings, not make a mess, etc. And takes pride in their work.

When a ceiling light in the corridor was changed, it was found that there is a hole in the ceiling where the prior fixture was and the new fixture is smaller. Please patch the hole hole in the ceiling with a matching texture paint. I have received one opinion that it is Polytex.

We had an oyster light removed and replaced with a ceiling fan, leaving behind a small hole that needs patching. I'm happy to paint it afterwards, just need the plastering done.

1.Cut, glue and fix one piece of gyprock to a masonry wall with supplied materials. No patching or painting. 2.Hang a supplied interior door and fix hinges, and handle. Probably take half a day, max.

We need the wall in our stairwell replastered where it has been taken back to brick (see photo).

Some walls and ceiling patch up

I am looking for a gyprock specialist to fix a hole in my ceiling in my lounge room. It is about 1metre x 1 metre big.

The kitchen wall needs to be Patched / Plastered where the old Rangehood used to be.

Mount an 85 inch TV on a wall using the mountains frame I have. Need to find studs in gyprock wall. Mount a picture frame (3 screws for a panel of wood into gyprock - see photos). It’s a simple job. Bondi Beach Please let me know how many hours you would estimate it would take.

Took a picture down and it’s ripped the plaster off