Find trusted mechanics near you

Looking for someone to re-gas the air conditioning in my 2017 Hyundai Accent sedan. AC is not blowing cold.

Range Rover Sport 2007 engine oil cooler and bushings I'll pay for the parts

Range Rover sport 2007 diesel engaging oil cooler and all bushings change I'll pay for the parts

Ignition struggles, error code P0087, smell fuel at the back of the car. Need to check the fuel pump housing and seal or replacing the whole pump. Car is a Ford Focus2013 Petrol Automatic 2.0 Litres.

Front brake pads fitted to my SUBARU FORESTER. I have purchased the brake pads and brake fluid. I just need them fitted.

Install a Sony XAV AX3200 Apple CarPlay unit into a Toyota Corolla 2014

I'm looking for someone to come over and install a head unit I purchased off of Amazon. If you know what your doing I'm sure it would be a pretty straight forward job.

Looking for someone capable for installing third-party head unit and reverse camera into my 2017 Lexus NX200T. Link to exact head unit contained below - unfortunately no installation instructions from manufacturer. https://autossport.com.au/product/lexus-nx-nx200-nx200t-300h-2014-2020-headunit

Replace front and back brake pads and rotors on my Nissan Qashqai

I'm needing my front brake rotors, pads and sensors changed over. I have the parts, I am just requiring someone with brake, steering, suspension and /or mechanical knowledge to remove the old parts and install the new ones. Car make and model: 2011 Audi Q5 SUV Wagon, 2.0L TFSI turbo petrol (Rear pads and rotors have already been replaced)

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method

Brand new bull bar Location in hawthorn I can be their to help lift the bar in place

I have a 2010 Mitsubishi Triton Diesel 4x4. Needing fuel pump purchased and installed please. Location the car is at is Yatala, stanmore road. I believe tank needs to be dropped and pump is on top. If you can help , please let me know.

Install a bullbar and original sensors attached to the cars original bullbar. Install the bullbar in the photo below

Need a qualified or experienced mechanic to replace rear brake pads on a Mazda CX-5. • ✅ Parts already supplied • 🔧 Labour only required • 📍 Location: Yarraville • ⏱️ Timing: Within the next hour (urgent job) • 🚗 Vehicle is ready to go Should be a straightforward job for someone who knows what they’re doing. Please bring your own tools. Prefer someone with experience in brake work.

Replace the clutch slave cylinder & clutch master cylinder on a 1991 Toyota Coaster. Have purchased new parts already. Would be just a few hours of labour. Important to bleed the clutch system at the same time as replacements. Flexible on day/time. Location North Adelaide.

Need to replace brake pads of my toyota camry, the rego is UUP676, its a Victoria number plate , please quote me offers thanks

I have installed an aftermarket Pinnacle head unit in my 2017 Mitsubishi Lancer ES Sport. The head unit is fully installed and working (audio, power, etc.), however the factory reverse camera is not currently connected. I need someone to finish the job. Important notes: * The head unit is already installed (no full install required) * Access to wiring behind the dash is already available * Looking for a clean, professional finish

I have engine oil and air filter. Need to change. I will come to you. Also take the changed oil with me.

I have a landcruiser 100 series with petrol engine 2uz-fe. I have timing belt kit already and need someone with experience to replace this timing belt