Find a professional gate installation in Burleigh Waters

I am looking for an experienced gate installer/fabricator to supply and install two new aluminium gates for my home in Burleigh Waters. The goal is to properly separate the front and back yards while improving security, functionality, and appearance. We have dogs, so I am looking for a clean, modern design that is secure and dog friendly. Current setup: * Existing front gate to be replaced * Side access currently only has a temporary plastic chain (no gate currently installed) Photos of both areas are attached. What I’m looking for: * Supply and installation of: * 1 new front gate * 1 new side gate * White powder coated aluminium to match the existing fencing and front wall * Vertical slat design preferred to reduce the chance of dogs climbing * Secure, high quality latches and hardware * Clean modern finish Front gate notes: * Existing timber brackets/posts around the front gate will also need to be replaced * I would like these replaced with matching aluminium framing/posts to suit the new gate and create a more premium, consistent look Smart lock/intercom: I recently purchased a new Eufy home security camera system and am considering installing: * A Eufy wifi smart lock * And/or a Eufy intercom system Ideally looking for someone who: * Has experience with smart gate access systems * Can install or work around these products during the gate installation * Or can advise on the best setup/options Open to recommendations on: * Gate design * Slat spacing * Hardware * Smart lock compatibility * Soft close options * Best way to future-proof the setup Please include: * Photos/examples of similar work * Approximate pricing * Timeframe * Whether you can supply materials * Experience with smart locks/intercoms (if applicable) Location: Burleigh Waters, Gold Coast Looking for a high quality finish from someone who takes pride in their work.

Seeking help to remove soil and level ground around house before spreading out 20mm aggregate gravel. Wheelbarrow and shovel supplied. Pay rate $35 per hour, set a $100 budget which can be adjusted up or down depending on hours worked. Available times 9am to 3pm Thursday 21st and or 11am to 3.30pm Friday the 22nd.

Installation of stratco gate to existing colorbond fence. Have the materials already, just need help with installation. Similar to the one pictured.

Remove old timber fence and gate - replace with new - slatted?

Replace Sedbury digital keypad. Keypad is supplied.

Need hinges on pool gate changed and timber fence propped up

Fix on some wooden panels on my driveway gate .The drive way gate needs the top horizontal wooden panel reattached so it can move with the roller that helps assist the opening of the gate. One vertical panel has also come loose and needs to be reattached

Need help with getting front gate lock installed

Front gate has had the wheel come off when i had to manually open it while we had no power. Electrics are working fine just needs to be lifted up and the wheel put back in i think? Also the handle has come loose on the entrance gate and needs to be tightened.

The gate has fallen loose due to wind. Help fix the hinge back onto the wall. Help tighten the latch screws. Preferably fixed today 24 Jan 25

Open 1.2m wide gate to existing fence Fence is 1.8m h

Toilet roll holder fit New lock on outside gate A door stop in laundry Rehang bedroom door

Custom fence gate door. Surface material ideally copper/ brass cladded.

Small side gate is missing gate stop on right hand side which means it can open the wrong way against the hinges. You can see the left stop on the left, looking for someone who can supply and install something on the right hand side that will match, thanks

**Solution + Quote Needed** The entrance to my property is a mud pit. It’s the only way in or out of the property, so you have to walk straight through it. This happens every time we have a lot of rain, but it’s at its worst now. The gate has also sunk due to all the water and is now resting straight onto the cement and it’s quite heavy to lift. I’m not sure what to do? I have approximately 300 square pavers that I was thinking could be used? I’m on a huge budget, so I need cheap ideas/solutions? Can anyone help?

1. Mount TV to wall (I already have bracket): TV: https://www.samsung.com/au/tvs/qled-tv/q60a-75-inch-qled-4k-smart-tv-qa75q60aawxxy TV Bracket: https://www.bigw.com.au/product/vogel-s-tvm-3605-large-fixed-wall-bracket-mount-for-40-100-led-oled-tv-black/p/9900007931 2. Mount dryer above sink (I have brackets): Dryer: https://www.thegoodguys.com.au/fisher-and-paykel-7kg-sensor-dryer-de7060g2 3. Install baby gate by drilling 4 points into door arch Baby gate: https://www.bigw.com.au/product/dreambaby-liberty-security-gate-with-smart-stay-open-feature/p/821418?

Require a gate installed side of house to keep dog away from front yard. Flexible with dates but asap. Dog currently destroying newly laid grass. Recent new front fence installed by contractor who doesn't have capacity to return for gate. If quoting please include materials - or book a time to come and view and quote.

Hinge on top of gate has broken. Needs replacing. Welding may be necessary.

I need my front gate re-hung. Simple job. Gate is wooden (and somewhat heavy). Gate is currently hanging but hinges need re-aligning etc. Will not take long for a person with the right tools. - Due date: Needs to be done on Wednesday, 6 September 2023

Supply and install wooden side gate. Width of opening is 1270mm. Want 1800mm high. - Due date: Flexible