Find a professional gate installation in Robina

Remove and replace rusty old gate hardware with new gate hardware. Can use fixings shown but they are not holding/catching in exisiting holes and new fixing have not been provided FYI.

Replace a n electric motor for a concrete pad

Concrete pad for electric gate

Garage gate limit fixing centsys

I would like a quote to remove a section of Timber Fence to replace with a Gate.

Need to install new timber gate and side panel. See photos of old one.

We have new gate/fencing but front folour doesn't suit House. Happy to purchase primer and paint and for you to supply spray gun and labour

Looking for a someone to screw two corrugated sheeting panels to a wood frame. They will be laid at an angle from the townhouse wall and going down the frame at an angle. Sheeting and roofing screws will be provided, so only paying for your labour. See photos of dimensions.

Fix cracked tiles x 2 plus finish with grout Adjust outside gate locks that don’t close properly

Broken tiles x2 mended plus grout Side gate latches adjusted to close

Cracked tiles need later to fix .. plus some grout Side fence and pol gate latches adjusted

Pour concret slab ( or a mix of slab and pavers ) to consolidate garden fence. As per the picture, the concrete around the fence’s posts is now above ground. I’m open to any other ideas. Please supply all materials.

INSPECTION ELECTRONIC GATE

Install baby gates & top & bottom of staircase (we have purchased the gates) The following needs to be anchored, I don’t have the brackets / wall mounts. Can you please provide or source them? Anchor TV unit & TV to wall Anchor 2 bedside tables to wall Anchor change table to wall Thank you

Two storey townhouse with flat metal roof. Tenant has reported water stains on ceiling in two upstairs rooms. Need leak sourced & repaired

$50O to include materials and labour. Must be fixed price. Handyman needed to install a single walk through gate in an exisiting timber fence using timber palings. Fence panels are 180cms. materials required post installed on both sides of gate gate latch hinges fence railing for vertical beam on top of gate bag of cement 1 step up to gate(maybe a sleeper) (other side of photo) screws I would like it completed next week

Build two fences 2 m wide each, approx 1.5 high, with a gate in the middle.

Colourbond gate hinges raised and reattached so gate sits higher and doesn’t hit the ground. Latch will need moving up too please so that it closes well.

All materials supplied on site see photos. Gate needs to be concreted in with post and then use premade (cut to 40cm side panel)along with a already premade gate - see photo Gate and timber is merbou from bunnings already on site. Fit hinges and attach hardware .

Current motor is 20 years old has died