Book a reliable freezer installation and repair service near you

I have a Hisense HRTF205S refrigerator. There is a strong unpleasant odour coming directly from the freezer air vents/wind channel. The freezer has been cleaned, but there is visible contamination inside the rear vents. I need a technician to remove and inspect the freezer wind-channel/rear evaporator cover and clean the internal air path, fan and drain area.

I’m looking for someone experienced with Miele integrated fridges/freezers or similar high-end integrated appliances to install a brand-new Miele FNS 7740 F integrated freezer. This is a replacement for an existing Miele freezer and is essentially the same size, although there have been some minor model updates. The freezer comes from Miele with the door opening in one direction, but for our kitchen it needs to open from the opposite side. Apparently there is a proper procedure for changing the door opening/hinge arrangement over, but I’m not familiar with how this is done, so I need someone who has experience with this type of Miele installation and knows the correct process. The job involves: • Changing the freezer door so it opens from the opposite side. • Moving/lifting the freezer into the existing cabinet. It is quite heavy and needs to be raised approximately 20cm into position, so suitable lifting/trolley equipment will be required. • Sliding and securing the freezer correctly into the existing built-in cabinet. • Reattaching/installing the existing timber kitchen cupboard panel to the front of the integrated freezer. • Adjusting and lining everything up so the freezer door opens properly and the timber panel sits straight and flush with the surrounding cabinetry. The previous freezer has already been removed, and this is a replacement unit going back into the same cabinet, so the cabinetry and existing timber front panel are already there. I’m specifically looking for someone who has installed Miele integrated appliances before, particularly the FNS 7740 F or similar, and is confident changing the door opening arrangement correctly. Please only respond if you have experience with this type of installation and have the appropriate tools/equipment.

My freezer currently isn’t functioning properly, it’s a fridge at the top and freezer down the bottom, I think the temperature function could be faulty as the freezer temperature goes from -19 but to -25

2 jobs 1) our freezer has no door handle - we need you to find one and install for us 2) this drawer’s front plate has fallen off - looks like it was welded or glued - just need this one liquid nailed or something similar

Hi , I think Samsung RS22HDHPNSR -SR24, side by side dboule door samsung fridge freezer , was working very good contidtion started ice building on freezer compartment. Need servicing at home . quote please . looks like this model RS50N3C13S8. has ice and water dispenser

Hi , I think Samsung RS22HDHPNSR -SR24, side by side dboule door samsung fridge freezer , was working very good contidtion started ice building on freezer compartment. Need servicing at home . quote please . looks like this model RS50N3C13S8. has ice and water dispenser

Can I please get someone to look into the freezer section of the Beko fridge/freezer? There’s a section in the freezer part that has popped out and it makes it difficult for the freezer to shut properly. See attached photo.

My freezer stopped working. We have an LG inverter linear.

I need brand new fridge/freezer and dryer hooked up in new house to be able to use plumping water function of the appliances.

Looking for someone experienced with reversing fridge doors, ideally a tradesperson, appliance technician, or someone who’s done this specific job before (not just general handy work). Fridge is a Samsung 427L Bottom Mount Refrigerator (SRL4200S) What’s needed: - Reverse the door swing direction on my fridge (currently opens to the right → needs to open the other way) - Includes moving hinges, and any stoppers/kickplates to the opposite side - Please bring your own tools

Freezer isn't working, the temp is only at 26 degrees and won't go down to minus. Might need re-gas. Located in Coventry Village, Morley.

The LED light at the top of the fridge is flickering, requires replacement or repair.

My freezer isn’t staying cold - it could be because of a grate coming off or broken seal but not sure. Photo of fridge/freezer set up and brand in pictures.

Brand new ikea built fridge and freezer goes into custom made kitchen cabinets. May need to change into ikea hinges since original ones are too big, which are supplied. Plan attached for your reference. Must experienced in installations.

Looking for someone experienced with appliance installations to reverse the doors on my Hisense fridge/freezer. The job involves: ● Reversing the fridge and freezer door swing (currently opens the opposite way to what I need). ● Ensuring the doors are correctly aligned and sealed after installation. ● Transferring the handles and hinges as required. ● Testing that both doors open, close and seal properly. The fridge is already in place, with good access. Please bring any tools required for the job. Experience reversing fridge doors is preferred. Please include your availability and fixed price when making an offer.

I have a fridge with a reversible fridge door but manual says it needs a technician to do the job.

I have moved house and my LG GT5S 375L Stainless Steel Top Mount Fridge opens the wrong way, currently on the right. Need someone to please reverse both fridge and freezer door to other side

FF E on display. Defrosting would normally solve it. Fridge is 3 years old. Alarm popping up more frequently. Please provide quote and earliest date available, possibly this week.

Hi, I'm looking for an Airtasker to help diagnose and fix an issue with our fridge/freezer. It is a Liebherr SICN 3056 (French door integrated fridge/freezer) The problem is that the freezer isn't cooling adequately. With the thermostat set to -24°C, I'm measuring roughly -1°C on the top shelf of both sides and around -6°C on the lower shelf. The fridge section appears to be working normally. The issue may have been caused (or at least made worse) by my attempt to defrost some ice build-up on the top shelf of the freezer using a hairdryer. I've since learned that's not the recommended approach, so it's possible something has been damaged in the process.

Temperature stuck at -8°C: The set point is -22°C, but it won't drop further. ​Ice blockage suspected: The compressor light (snowflake icon) is solid ON, but I can barely feel any airflow from the evaporator grilles inside.