Find experienced local fencing contractors in South East Melbourne

Build wooden arbour and lattice on both side near fence

Garden retaining fence needs to be fixed

The bottom of the fence board has loosend and is coming away from the fence.

Install 4.8 m long and one 975mm gate inside a factory Will need drilling into the floor(concrete) I will supply the fence and gate etc Install only Located in pakenham

Garden wooden fence 1.8m (no cap on top) posts broken in 2 sections of the fence, and a 13m stretch has fallen down. 1) Need to replace the broken/damaged post (not more than 6pc 125mm x75mm 1.8m high) and 2)demolish/remove a straight section of 13m fallen down fence and rebuild it (post defined in section 1 above, to do the 3 horizontal frame and add palings (100mm x1.8m and 150x1.8m palings) 3) Remove fence rubbish Photo notes: 1- first photo is the 13m stretch where there are 6 posts and the 4 in the middle are broken. ie. you have to demolish that fence (possibly in 5min by cutting the 3 horizontal fence rails on both ends, and the fence will fall down). I think that the end posts are still viable, or at least one (I'm not a fencer), making it 5 posts replacement at the most. If both sides are viable, you can install 5 posts to replace the 4 broken posts (saves you digging up the concrete for the 4 broken posts). Leave that to your creativity. 2- Second photo shows a broken post with the fence still on it. Actually the fence has 'detached' from that broken post and is being propped against it from the other side. The broken post is therefore a 'stand alone' post and I would like it replaced that post and attach back that fence. 3- 3rd photo shows two piece of fence wood used to prop the fence against the broken post shown in photo number 2. If you remove the props, you can 'demolish' that broken post (see photo 2) with 1 hand. Need a replacement post. Hence, my estimate of just treated wood material for the 1.8m fence is: 6 x 100mmx100mm posts, 3x13m fence rails, and 100mm & 150mm treating palings for 13m.

I am looking for someone to remove an existing gate and re-install a new about 1 metre wide aluminium garden gate. I will supply the gate and accessories.

Garden Fencing repair : Broken fencing to be reinstated.

Need to fix a new metal post to concrete floor base and brick wall 🧱 also need to bolt the steel frame gate to the post. This is the gate on side of the house. Post has come off the wall, i have bought a new post with holed baseplate.

Require a 2.7 m(wide) & 1.5m(high) wooden gate replaced with a equivalent colorbond fence - Due date: Flexible

I need someone to replace new post and install a garden double gate. Remove old timber post, dig min 600mm deep hole near the corner of deck to concrete in new metal gal post, paint the post and put up the same sail shade . Install a new double gate on driveway appx 3.5M. Hinges on carport post and brick wall with exisiting shade sail post but shorter. All materials are supplied, tools on you.

Hi Soul, you have replaced 3 in the past, would it possible for you to replace the remaining last one. last time when you checked it was good but now seems to be rotten on top.

Looking to replace existing garden side fence with either metal or timber fence with gate - Due date: Flexible

needs to replace a post and a few meters (2m) of the fence on either sides of the post. I pay for the material separately. - Due date: Flexible

Part of the fence fell down, probably due to uneven floor and old poles. I would like to replace it.

I'm looking for someone to help build a fence trellis in my front garden similar to the one attached. I'm fairly handy and would like to help, Ideally you'll have all the tools and experience to get the job done, wth my help. - Due date: Flexible

Replace timber fence with colourbond abt 37 meter

Have bought 9 metal panels (2.4 m x 900mm) and poles including fixers and screws. Panels are new but posts are little old. Maybe needs shortening or adjust height while erecting underground with quick cement. Two gates (1m gate and another 2m gate) between panels needed. It’s a garden fence to keep dog away from certain area. Have all materials ready to go except for the gate clamps and latch..which could be bought as per installers instruction. I can be a helping hand. Have basic tools but better to have own professional tools. Cutting of panels maybe required in two or three places. Having a small petrol pole digger can save lot of time and effort. Got the manual ones at home already. Prefer to finish it this weekend. Posts are not like the ones in the picture but large thicker ones. Got it from a friend. But can be used. Give your quotes pls

I have this vertical garden grass that needs to be installed on the fence. See photos attached, the length of the fence is about 3.4 m so not a huge job but I need someone with the tools to be able to install it.

Install 24m pailing fence 1.8 high with cap. Remove the old one cut and store to re use for heating.

Timber garden steps and dividing fence gate damaged due to severe weather. Looking to get them repaired in the next week or so.

There's a 75cm space between brick house and tin garage that needs secure, strong dog proof fencing. Concrete base and needs to be around 152cm high.

Need to fabricate aluminium vertical blade fencing all material provided by me just need to weld It

We have got 3 escaped goats. They are on neighbours property 21 hectares. We have try to chase them several of times but no chances. They went through fences like nothing. I have set up the catch pen from 2.1m height temporary fence in construction. I would love to hire herding dogs to herd them into the catch pen so I can put them on leash. I would also like to give them away. So if you can catch them and you want them. It’s all yours.

We have a dog kennel that need to be built. It has an instruction manual and all the materials to put together but we are struggling to put together.

My dog has decided to chew the bottom of my timber side gate to escape. I just need the it fixed for the realestate

I am needing chicken wire installed under fence line to deter my dog from escaping About 15 -20 meters I will supply chicken wire plus pickets and any other materiel needed Type of gardening: Other Size of garden: 50m²-100m² Has green waste bin: Yes

I need help for Dog Fence

Large metal dog run approx. 600 x 200 x 150 Just needs to be put together, all parts are here.

Need someone to move the fence 8cm inwards as it was installed on wrong boundary. The fence is new and can be used. Only require someone to relocate it using the same material. - Due date: Flexible

Need a customized pool gate fence installed in a pet salon. Need to come measure the size and install - Due date: Flexible

Hav materials need someone to put up dog fence wire - Due date: Needs to be done on Saturday, 19 August 2023

I would like pet mesh to be installed to front fence to stop dogs from sticking their heads out of opening in fence. Approximately 15 metres in width. I would consider pretty much anything as long as it stops the dogs from sticking their heads outside the fence. Anything that could be done cheaper would be greatly appreciated. - Due date: Flexible

I want a 1.5 metre fence built between our house and the side fence. I would like to know the difference in cost with a gate and without a gate. - Due date: Before Saturday, 24 December 2022

Please note budget is just a Guesstimate. Have 5 dogs. Need to separate backyard from front yard. Approx 29metres in total. We want at least 1.2m height. Will need 2 pedestrian gates. Need cheap but solid enough to cope with big dogs, no gaps underneath or in between for small dogs. Would love this done in the next couple of weeks. Ideal is composite timber batten fencing but not sure if that can be done soon or not. We do have a curved area that has edging that needs to be followed.

We have an electric dog fence kit we need installed in our backyard - Due date: Before Tuesday, 20 September 2022

I’m needing a secure fence put up to create a small yard for my dogs. I’m wanting it to be built with either pool type fencing or mesh. Not sure how much something like this costs so please let me know of your pricing :)

I need help securing back fence do cat cannot jump over and escape. There is a gap between fences and climbing posts. Perspex has been delivered. - Due date: Flexible

Relocating the fence outwards to a meter and extending it up to 6 meters, if new fence is recommended the whole length would be around 12.5 meters and installing a single gate at the side

Supply materials and help build a large enclosure for dogs on the side of the house. 1.2w x2.8d x1.5h Clyde north location.

Carpenter build fence with gate to keep pet out.

job required at 2 different locations: Crabourne: Replace current gate with new colour bond gate (image attached) Pakenham: Scope of works: 1. extend colourbond fence by 5.3m 2. 1 x colourbond side gate - 2m 3. 1 x Colorbond side gate - 2.1 m

Colour bond fence gate side entry

Looking for someone experienced with colourbond fencing to do install and remove old 30 metre fence (labour and disposal of fence only) we have order the materials with Stratco.

Remove and dispose of old fencing supply and install new color bond fence

Side gate installl on existing fence. Budget $350. I supply gate , post ,screws, bolts and nuts. you will supply 2 side rails and one post same color to complete the gate install. Door will be installed from the centre to be able to swing properly because heater unit is on the way.

I need 12 m Colorbond or paling 1.8 m high

Needing a quotation to reinstate or replace existing colorbond fence has been damaged from high winds. The fence is currently attached/Fixed to a concrete planter which original fencer suggested. Permanent solution looks like it needs to be posted into ground? Fence is 2M high (including 200mm extension)

I have all colorbond panels plus the post and rails with the screws. I need someone to install. Will need concrete and plinth boards. Easy access back fence only 16.5m long.

Remove existing wood fence, install colour-bond fence to approximately 2 mtr high Bottom plinth to be concrete not timber

Need to replace broken fence and gate with color bond

Approx 18m fence + a gate. Installatioin of stairs. Something simple - Bunnings stringers+stair treads. Demo+waste disposal.

I wish to extend the height of a colour bond fence for extra privacy. Approx 11 metre fence. Prefer lattice colour bond extension

I want the current timber fence to be removed and replaced with 2.4 Mtrs tall colourbond fence. 30 mtrs long

Fencing on one side with 1.8m precorrugated sheets colorbond woodland grey or color matched fixed to timber frame with 45 degree pyramid shaped top with a timber peak fence capping: approx 14m + side gate. You buy materials + labor

Culla born Fence 67 meters

Im looking for a quote on replacing our fence with a new colourbond fence. Height(using extensions if we have to) of no less than 2400mm. Want to avoid having to do a permit. Location is Hardy Court, Berwick, we have permission from neighbors, and fence is easy access from both sides (other side of photo is actually a roadway), are you available to provide a quote? - 21m long and yes please dispose old fence

26 meters colorbond fence

Need someone to supply & install approx. 4m of colorbond capping for the front part of our single garage. Please see images (along the top indicated by yellow line). Colorbond colour to be 'surfmist'

Need fencing along the back of my property and a lockable side gate Want colourbond fencing. 16m length at back. Edit: will need sleepers below each fence panel, 400mm tall before fence start

Remove old wooden fence and dispose of Install 32 metres of colourbond fencing , with wooden sleepers at the bottom