Find trusted local electricians in Glen Waverley

Post Kitchen refresh Install new range hood wiring already in place Re connecting 2 power outlets to existing wire Swap over 2 under bench lights to new (supplied) Swap existing ceiling light to larger version supplied Relocate that removed kitchen light to another one.

Need to know installation cost on a single storey house . There is no split system at the moment I have Mitsubishi unit need to be installed

The existing downlight appears to be hardwired; need to install a plug connection and then fit the new downlighs . There are 6 of them.

I would like 2 internal wall lights installed. 5 wall switches relocated. The relocation won’t need additional cabling. Just move back the wall switches about 10cm allowing space for my renovation job

7 floodlights to install for a single storey house. Have access to ceiling from inside the house via ceiling door. 2 at front of the house, install on eaves, need to install a new switch indoor to control the lights. 2 at the back of the house, also need to install a new switch indoor to control the lights. The rest 3 need to install on different sides of the house, they need to wire to the existing floodlight/outdoor loop, so they will light up together with the exisiting floodlights.

Replacing old Aquamax HWS to new Aquamax G390SS

Change 3 old dimmer switch to normal switch. Change 1 old fluorescent tube light fitting with a standard LED light fitting. We will provide all switches and light. Everything install on same location

I need to replace 1 No. switch with a dimmer switch 1 No. faulty outdoor sensor (motion&light ) I have purchased both the items

To replace fuse main box soonest possible.

I need to replace 38 existing builder-installed ceiling lights with new LED downlights, 34 indoor, 4 on alfresco. I'll supply new LED lights which are Mirabella 5-Colour Selectable LED Downlights. Scope of Work: 1. Remove 38 existing ceiling lights (standard batten holders). 2. Install & set color temperature of the lights before mounting. 3. Test all switches to ensure flawless operation. 4. Clean up. Requirements: 1. please provide your license number in your offer 2.Public liability insurance is preferred. 3. Electrical Safety Certificate to be provided upon completion.

Urgent – Electrical Works for Study & Built-In Bar Looking for an electrician to complete the following works: Photo 1 – Study - Wire/provision 3 x double GPOs now - Return after the study cabinetry is installed to finish/install them - Remove and cap off 1 existing GPO in the corner, as this area will be enclosed by the new cabinetry Photo 2 – Built-In Bar - Install 1 x surface socket at the top - Install a switch at the marked position to turn the surface socket on/off - Finish off 1 x double GPO where wiring has already been completed Photo 3 – Separate Room A new backboard will be installed Bring the existing GPO shown in the photo through the new backboard and finish it off Backboard cut-out will be done by the cabinet maker Other details - Single-storey house with roof access - I will provide 4 x double GPOs and switch - Please allow to supply 1 x standard double GPO - Ideally looking to get the initial works completed this Friday, or over the weekend if that suits Please advise availability and quote.

Need 2 existing power points moved approximately 150–200mm to the right to clear new built-in bar cabinetry. The area will be completely covered by cabinetry, so the plasterboard can be cut/opened as needed to make access and relocation easier. Need this completed ASAP

Flexible with timing. Please send through offers. Photos including AI image of expected outcome thanks. Task1 Install 2 supplied pendant lights (IKEA) over a dining table on ground floor of 2-storey house with new circuit added to either existing wall switches (existing downlights) or new wall switch location (Electrician to please provide either Clipsal Iconic updated wall switch in Vivid White or new Clipsal Iconic switch if new location) - 2.7m ceiling height. Existing downlights x4 on 2-way switch. - Existing downlights may provide access for cabling and preference for minimal plaster cutting - please advise if expecting to damage plaster. - Plug bases preferred Task2 Install a new GPO on kitchen island laminate panel - Clipsal Iconic Vivid White series (electrician to supply). Existing Microwave/dishwasher power outlets already present for back-to-back install in kitchen island. Licensed Electrician please - am also after assessment of mains upgrade.

I need one new powerline/socket to outdoor area to plug in electrical pergola roof, LED light and 1500W heater. Sooner the better. Thanks

I have an old ceiling fan in my covered patio that needs to be decommissioned and replaced with a new ceiling fan. The current one is possibly AC fan, and the new one is DC fan so need to ensure this can be achieved. The current fan is operated by a dial with 3 speed settings. The new fan would be this one: https://www.templeandwebster.com.au/Alina-132cm-DC-Smart-Ceiling-Fan-with-Remote-Control-AART1643.html The fan is arriving Friday 24 July so looking to get it installed this weekend.

To install a ev charger at home

Bathroom IXL fan not working, no sound. Need licensed electrician

Replaced tubes but still not working. Need to check conncection and fix

1) Got 10 downlights already installed in my patio need to connect them to a new or existing switch point . 2) Need to install 1external plug point with option to plug two plugs

Air Conditioning Removal * Remove the existing air conditioning unit. 2 units * Remove the electrical isolator. * Make safe all electrical connections. Reinstall all the removed air conditioner units and isolator after wall finished. * Dispose of removed materials and leave the area clean.