Find experienced local carpenters in Robina

Set up 6 x 5 metre lines to fixtures already in place. Budget $100/hour. Equipment on site

Hi, I’m looking for someone to repair or replace some external timber trim on my townhouse in Robina, QLD. The timber is weathered and may need sanding, treatment and repainting, or partial replacement if required. Please provide: – Your availability – Estimated cost – Experience with external timber repairs Thanks.

Hi! I need someone to install a simple timber trim/frame around a bathroom window to neatly finish the edges around my plantation shutters and cover the visible gaps. I already have the measurements I will buy the timber and get Bunnings to cut everything to size So this is mainly installation/labour only. Job includes: • Install pre-cut timber pieces around window/shutters • Fix securely (nails/screws + adhesive as needed) • Ensure straight/level and neat finish • Light filling of nail holes (optional) own tools required, eg drill/driver, level, fixings, nail gun (if preferred). Small job ☺️

I’m building a cabinet for my salon it needs space for a fridge and towel warmer which I have the dimensions and cupboards and draws to be able to store stock I have a diagram but open to changing certain things if it’s easier Also wanting a cabinet above it so I can have shelving attached

Wanting a screen built in staircase area. References included. Wood with white paint finish.

Wood outdoor doors require staining

1500 wide 1100 tall window, Replace timber frame and sills

Currently, cavity space for fridge does not fulfill the height requirements of most fridges. Looking at getting the cabinet above altered (made smaller by moving the bottom up) so that frees up more height in fridge cavity. Pictures included.

I have a bedhead which I need help shortening height wise and then adding sides to it in a custom design. I can arrange all the bits and pieces (extra wood/screws/plates) for it, I just need a man with some tool magic to bring my vision to life! The quote price is $5 as I am open to offers :)

2 jobs 1. Ikea 1900mm kitchen cabinet needs to be reinstalled against the external wall (excluding sink unit and plumbing). The current 2 section bench top to be replaced with a new 1800mm Ikea benchtop to be cut and installed in 2 sections roughly 640x600 and 640x450. 2. Ikea push to close draws in the fully assembled laundry cabinet need adjusting as they are not opening when pushed.

Kitchen cupboard door missing and some draws. These need to measured and sent for manufacture and then installed. Need an experienced cabinet maker that can do this task. Have more work in the pipeline. We will pay directly for the materials and manufacture. You measure and install once ready

Need 2 small cabinet doors made up with 16mm white mdf or particle board (matt finish) with trim around edges and hinges. Measurements 430W x 425H

Hi, I need to frame an internal partition wall inside a 2-car garage. No doors or anything. Just a basic partition frame (parallel to the garage door). Thanks

Hi everyone, Looking for someone who can create/install some shelves in an existing built-in cupboard that we have in our living room! (Please see photos attached). We were wanting about 8 shelves - only on the right side of the cupboard! Needing to drill shelf pin holes too. Measurements: approximately 223 cm height - 31 cm length - 56 cm depth Please send quotes - thank you!

Set of carpeted stairs from landing to living area need stain removal and cleaning.

I have purchased 9 "prempanel timber slat panels" and need some of them cut to size to fit into a smaller area and all of them attatched to a wall. We are in a hired space so damage to the existing wall must be minimal. Someone with carpentry experience would be preferable. Photo with the panels and greenery up is a mock up - we are just wanting the panels put up as seen in the mock up

I’m looking for someone to clean and stain my newly built deck, which is approximately 50 square metres in size. Cleaning: I have a pressure washer available for use to ensure the deck is properly cleaned before staining. Staining: I will provide the stain needed for the job. Looking for someone with experience in deck cleaning and staining to help ensure a professional finish. Please include any relevant experience and let me know your availability. Thanks!

Single oil stain on paved driveway needs to be treated/cleaned. Approx build up over 8 months. Stain is less than .5 Sq metre. I understand from research it may not disappear completely but some reduction in colour would be good. I am leaving a rental property.

We’ve recently had a dishwasher installed and there’s space between dishwasher kitchen cupboards. Need a qualified, experienced cabinet maker to fill the gap as we need a very neat job. We have a sample that can be colour matched.

After a custom baby gate to be installed and made. Similar to photos attached. Will need to be a builder or qualified trades person. Will need anchor and lock like photo.