Find experienced local carpenters in Palm Beach QLD

Cut down some shelves 30cm to match the size of benche top

Looking for a furniture restorer, French polisher or cabinetmaker experienced in veneer repair one oak-veneered cabinet door with a chewed corner (puppy). Damage is visible on BOTH faces of the door, wrapping the corner, so it needs to look right from inside and out. What I'm think im after: - Veneer patch inlaid on both faces, cut back to sound veneer - Edge banding replaced - Colour and grain matched to existing light natural oak - Sheen matched (matte to low satin) Let me know if you think otherwise WHEN QUOTING, PLEASE INCLUDE: 1. A couple of photos of previous veneer repairs you've done 2. How you’d fix it 3. Whether you work on-site or need the door removed and taken away 4. Rough turnaround

Require a stainless steel spot weld repair of two 316 outlets in a stainless tub.

I am having a dishwasher installed and just need some cabinet parts removed and a kickboard cut. Pretty straight forward job I believe.

Looking for an experienced cabinet installer / flat-pack assembler to assemble and install Polytec walk-in robe cabinetry in a WIR, with cabinetry on both sides of the room. Scope: * 1 walk-in robe with robe systems on both sides (2 near-identical runs) * Approx 2400mm wide x 2065mm high per side * Hanging sections, drawers and shelving as per attached drawings * All Polytec panels supplied and pre-cut by Flatpax * Hardware, screws, rails and components supplied * Assembly, joining panels, levelling and fixing/install only * Cabinetry / wardrobe install experience preferred * Neat finish required Photos and drawings attached. Please quote labour only and include any wardrobe or cabinetry installation experience.

Need a cabinet maker/joiner to rearrange some already assembled wardrobe cabinetry from room to room. (Disassemble small 2 door wardrobe from 2 rooms, move to other bedrooms, assemble end panels, make good) Needs to be first up on June 2.

We are wanting to ‘tidy up’ the vanity’s in 2 bathrooms before renting out - without complete renovation. The vanity drawers are flaking and need to be replaced. It’s a custom job and there are 3 drawers in both vanity’s

Make Banquet seating in an L~shape Dims 1300 x 1780mm length, 550mm height, 400mm width Hinged door for storage Ply or MDF ~ I’m planning to micro cement over it Quote to include all building materials please For my dining room area/ corner of the room

I have 3 x wardrobes and 1 x linen cupboard that need to be prepared for sliding doors. Also linen cupboard to have new shelving to replace wire shelving.

I have an aloe Vera plant that leaned on my blind and stained it. These blinds are black out. The stain is a medium size and yellow/brown in colour. If possible I would like the stain to be fully removed without damaging the black out blinds. Also I need the shower in the bathroom to be cleaned, removing all the mould in it. The mould is in the grout of the shower. Please and thank you! Type of clean: Regular Number of bedrooms: 3 Number of bathrooms: 2 Equipment and supplies: Tasker must provide

Deck needs light sand and stain. I have the stain. Approximately 40 sqmtrs

Install of 2 robes (plans attached). Palm Beach

1. Back deck - approx 5mtr x 3mtr. Existing deck in place but need to start again as existing posts, bearers, joists and decking boards are rotten. 2. Replace rotting fascia board in 2 areas

I got this far but need help sanding cabinet door down to size and mounting to the wall or other cabinets. Need someone to please put together my ikea kitchen island bench and also my Ikea kitchen wall oven shelf, no drawers. Need the push to open part of the wall cabinet you see in picture put on as well thanks. Ideally today if possible.

Looking for a cabinet maker to remove lower cabinetry, and pantry from the pictures provided. We need to access flooring underneath cabinetry. Please note: stove and oven have been terminated and removed already. Need to salvage cabinetry for reuse.

Wooden blinds came off.need to be fixed in Royal Palms ,4221 Palm Beach

We need an experienced professional to remove mild surface rust and polish high-quality stainless steel furniture without causing scratches. This will be done on a large balcony, and we have bed sheets available to protect the workspace. The rust developed during mild storage, so it should be relatively easy to remove with the right expertise. Items requiring treatment: Dining table base 2 Stools Occasional chair Requirements: ✔ Experience with stainless steel restoration ✔ Ability to remove rust without scratching ✔ Own tools & polishing materials Please provide details of your experience and availability. Example of the dining base below which is main surface area. Thanks!

IKEA kivik sofa 4 seater and corner. Needs deep clean and small stain removal.

Leant on the bench and snapped the overhang, I have the snapped piece if you can put it back together

This old wooden bench top needs to be replaced in our yoga studio. Either sanded back to remove the water marks and then revarnished or stained. Or replacd the whole bench top.