Find a reliable appliance technician in Templestowe

Poulenc ride on mower used

Hydrogen inhalation machine showing E3 error. Already flushed and refilled with demineralised water — no change. Likely sensor or electronics issue. Looking for someone with experience in medical devices, oxygen concentrators, or electronics repair. Need diagnosis and possible fix.

Bosch series 6 not draining properly

Connect natural gas pizza oven to existing gas outlet And core drill 35mm hole into timber substrate

My kitchen currently has an open gap above the cooktop. I’d like to have this opening closed up and then install a range hood(will have separate person to do the installation not include in this task list). It will probably require timber beams for structural support and some painting as well. Could you please let me know roughly how much this would cost?

Replace existing old gas cooktop, the original one is narrow in size, so probably need some small cut job on the benchtop.

We have a Dometic 3 way caravan fridge which will not connect which will not connect to mains power.

I have a ducted gas heater unit outside which is disconnect from power. It seems to be connected to gas pipe. I do not have gas at property at all. So it’s safe to remove. I want it disconnected and disposed off.

Washing machine is giving an E30 for a while - tried everything but still goves the error. Require someone to check it out

The existing oven is a Westinghouse POR663S 600mm built-in oven, which appears to be hard-wired. However, I am not 100% certain whether there is an existing power socket behind the oven or in an adjacent cabinet. The new oven is a Miele steam combi oven (plug-in type). If there is no suitable existing socket, the hard-wired connection will need to be converted to a compliant single GPO (power point) on site. Ideally, you are a licensed electrician who can carry out this work during the installation if required. Photos of the existing oven, cavity, and new steam oven are available for reference. Please include this potential work in your quote and confirm that you are experienced with built-in oven installations and Australian electrical compliance requirements.

The dishwasher is Midea WQP12-7617N. The display shows the E1 error and that water is pooling at the bottom of the unit.

Safely disconnect and uninstall existing 99cm slide out rangehood, install new 90cm rangehood and connect to existing ducts and power, check its working, remove old rangehood

Ice is forming near the vegetable compartment, and the fridge is not cooling as it should.

Fault has already been diagnosed in the top left door of LG fridge. This door dispenses water and ice. It is no longer dispensing ice due to a hardwire fault in the cabling. I am trying to avoid door replacement. GF-V910MBSL

My Dolphin S150 needs the front brush replaced. Depending on cost may also replace other parts. The front brush definitely needs replacing.

Replace existing old gas cooktop, the original one is narrow in size, so probably need some small cut job on the benchtop.

Electrolux ultimatecare 500 washing machine rubber seal replacement

Need to pressure clean this area tomorrow before lunch would be good No electric pressure washers please

Removal of a cabinet door and placing washer in the cabinet. Placing door back on

Hi, I have an Electrolux clothes dryer that’s started to make a loud squeak within the first minute of operation and then it goes away. Now it has stopped spinning.