Find a reliable appliance technician in St Ives NSW

we need the dead dishwasher taken away, and a dishwasher moved from one house to another. and installed - there is water in the old dishwasher - that has to be drained before you move it.

Older style petrol push lawnmower needs service and small repair (have the part - replace throttle and cable). Subaru 175cc motor on traditional body.

Our Esatto 9kg top-loader has suddenly started making a loud rattling/grinding noise, which seems to happen when it is trying to pumping/draining water. Unfortunately it is not draining any water. Suspect there may be something caught in the drain pump/filter, but need someone experienced with washing machine repairs to diagnose and fix it. The machine is in a fairly tight laundry space (photo attached), so it will need to be pulled out to access the rear/bottom. Machine otherwise appears to be working normally. Model: Esatto ETLW90B. Please quote for diagnosis/repair labour and advise separately if any replacement parts are required.

This gas cooktop has four burners ,but only one big burner of them is not lighting when spark ignition working.

My washing washing door is not closing properly and displayed the code U4

the tap supplying the washing machine is leaking and needs to be repaired

The belt of the treadmill needs to be replaced.

My electrician installed the steam oven on the bottom. But I wanted it on top, always have to crouch to use the touch pad. I need the steam oven raised to the top of my joinery cavity and convection oven lowered. It will be a two person job as the appliances need to be handled etc. Need someone who has dealt with Wolf brand appliances.

We have purchased a new built under double dish drawer Fisher and Paykal dishwasher. We need someone to remove the existing F and P dish drawer (see photo) and install this new one.

ILVE 90 cms dual fuel oven (model: Q Series P90 WMP) needs the following repairs: 1. Oven door doesn’t open and shut smoothly 2. Temperature knob has come loose 3. Rubber lining needs to be replaced

Current slide-out range hood needs to be removed and then new one to be installed.

Install a gas bayonet taking gas from inside kitchen cabinet wall to outside of same wall facing lounge room. It's a straightforward job, minimal distance to run. It's for an unflued gas heater. Easy access.

I have a Life Fitness 9500HR treadmill that is having power issues. I think the power cord was damaged whilst being moved and it could just need a replacement/fixed power cord.

Miele Washing Machine as water inlet and drain issues. I tried cleaning the drain in the front but not at the back. Also water inlet needs to be checked. Washing machine is below Dryer, The dryer would have to be removed to check the washing machine

My built-in gas fireplace ignites and operates normally, however the blower fan does not start even after the unit becomes hot. Possible issues may include: blower fan motor snap disc / thermal switch fan controller dust blockage The unit appears quite dusty internally and may require inspection and cleaning. Looking for someone experienced with gas fireplaces and blower fan systems to: diagnose the issue inspect blower/fan area test thermal switch / snap disc advise whether repair or replacement is needed I prefer repair if possible rather than full replacement.

I have a washing machine that needs to be serviced it is off balance.

Miele dishwasher not draining and flashing the f11 error. Removed the micro filter tray and the reverse valve to clean but none of them are causing the water to still drain. Need to come in to help with fixing the dishwasher Model - Miele Jubilee SC

We just moved houses, the connector of machine pipe to the sink pipe is broken during the move. I bought the spare part but hard to fit it. I need someone with more experience to do it

Replace 90cm canopy rangehood (existing duct & wiring)

LG heat pump dryer is working fine but it makes noise when I spins