Find a reliable appliance technician in Indooroopilly

My 2013 Vitamix blender requires testing and tagging due to the electrical cord being slightly melted (too close to stovetop) - has been working with electrical tape over since, but want to get it safety tested. Can deliver to you.

Install a hills clothes line. Need someone with 10mm drill bits to drill into masonry and then install the line.

I require the services of a licensed gas fitter to connect a 600mm Bosch natural gas hob in my alfresco area. The job also includes installing a secondary gas outlet to service a Beefeater 7000 Premium 4-burner BBQ. Please note, I will supply the necessary natural gas converter kit for the barbecue.

Dishwasher needs to be inserted into an existing kitchen set with a door. I'd like to keep the door if possible (i.e. integrated). The appliance is in place. Just need to fix the door into the front so that when you open it the dishwasher opens with it.

My outdoor Odin ice bath has stopped cooling. Water circulates fine but the condenser fan doesn’t start and the compressor doesn’t kick on, so temp stays around 22–23 °C and the controller throws an “HA” alarm. What it is: Chiller uses Tecumseh compressor: AE4460Z-FZ1C (R404A), LRA 19A Run capacitor on it is 64 µF, 330 VAC (round black can) Fan spins freely by hand but won’t start on power Likely fix (please bring parts to test/replace): 64 µF ≥330 VAC motor-run capacitor (for compressor) Start/overload module/relay for Tecumseh AE-series (or a suitable hard-start kit) 230 V condenser fan motor and fan run cap (typically 2–5 µF, 450 VAC) in case the motor is bad Usual electrical/refrigeration tooling to test for supply at fan/compressor and replace start gear Job scope: 1. Diagnose why fan & compressor aren’t starting (verify supply from controller/relay). 2. Replace failed start parts and/or fan cap/motor. 3. Prove operation: fan running, compressor running (discharge line hot), and water temp trending down. Payment Fixed price covers call-out + up to 2 hours labour on site (diagnose + swap start cap/relay and/or fan cap/motor if needed). Parts are additional at cost with receipts (no markup). If more than 2 hours is required, I’ll approve extra time via Airtasker at $120/hr inc. GST by prior agreement.

We have a fridge at home and the freezer part is working but not the fridge part. The light is on but no cooling air at all. If there are anyone who can help with this, please let us know

Our washer/dryer always stops near the end of every cycle saying 'Clear Filter'. We have cleared the filter according to Fisher & Paykel instructions but it still happens. We need someone to help us keep our sanity! Cost negotiable! Many thanks!

Wall mount a new clothes dryer in laundry on existing mounting point, Wall mount kit included with dryer.

Need to reinstall the smoke alarms in the house after repaint the calling. 2 Storey house, 5 bedrooms with 2-3 living areas. Please quote

Need to replace gasket in washing machine. Samsung. Already have new one to replace.

Need a plumber for installing a small dishwasher ( over the bench)

Help us fine tune our coffee machine so we can enjoy it again. May need repairs but could just be adjusting grind and pull time.

Want to replace stove top. I will provide stove top

Top Load washing machine stopped working, MAchine starts but not taking water , some issue with water intake or some broken water intake system

Need to install a new free standing oven to replace old built in one. Will require cutting the bench top...

Microwave not working, blow the main sewitch

Siemens washing machine filter cap won't open.

a washing machine and a refrigerator to another house 5km away.

I believe the compressor has died and the current refrigerant is the old type R134A so we need either a new or replacement compressor and replace the R134A gas with the new legal type.

I have a new dishwasher and fridge that needs to be plumbed in.