Find a reliable appliance technician in Centennial Park NSW

Have an Electrolux Ultimate Care 500 Washer & Dry. The washing works perfectly the Dryer kicks off an E10 error.

I have the extension lead Need someone to fit it o to washing machine and to grey water pipe under the sink see photos it’s the one with the sticky tape around it

Our Hisense washing machine doesn’t seem to be draining/working. Need fixing ASAP HWFV7512/HWF7512S/HWFV7512T

I need help asap. I need someone to move my washing machine so i can mop the water that went underneath, tilt it up so i can clean the filter without qater going everywhere (design fault means a plate wont fit under the filter area)and put machine back in place, make sure it's still level etc.

Fisher and Paykel Dishwasher issue. Error code coming up Not draining I have checked the filter and pipe, doesn't seem to be a blockage. Still running through a full cycle, but leaking due to not draining properly.

We need our washing machine to be installed. We tried ourselves, but it did not seem like the pipes would be long enough to reach the inlet and outlet (see attached) - you will see that the pipes would have to pass through two cabinets neighbouring the washing machine slot. We do not think we have the expertise to change pipes and install ourselves.

Once the water descends, the washing agitator won’t rotate. The spin cycle function itself works.

The washing machine isn’t washing properly. The agitator isn’t spinning during the wash although you can hear it trying to rotate.

I need to fix our Hisense front loader washing machine, model HWFV7512 ERROR F -13

I need the waste water pipe connected for my washing machine. Existing hoses available

Cap off water and gas pipe

I am planning on installing a new fridge but first I need help with the following: 1) offer advice on how I could best fit/support a fridge in the space. This could include you removing part or all of the wooden platform (and if advisable the metallic platform) that was beneath my old fridge 2) fix/ replace the white pipe which has a small leak 3) offer advice on ways that I could install my new fridge in a way where I am able to access the power plugs for the washer, dryer and fridge behind it (as I was unable to move the old fridge easily and thus was not able to access the power plugs behind it)

Four Vulex sky lights are not able to open despite changing the battery of the remote control May need re setting / programming

I need my Fischer Paykell 55AU clothes dryer mounted to the wall. There’s pre-existing mounting hooks on the wall but they aren’t compatible with my machine, so I’ve bought a new mounting kit. I’ll need someone with power tools to deinstall the old hooks and install the new ones and then mount my dryer to the wall. The dryer mounting kit requires an electric drill with a 3mm drill bit and an 8mm nut drive or socket. I’m renting so it will need to be done carefully :) I work full time 9:30-4:30pm so it would need to be outside those hours or on a weekend. Thanks!

Replace with new capacity gauge and possibly new regulator/ hose to a Webber BBQ. Can't seem to remove regulator from broken gauge.

Our Samsung Heat Pump Dryer is not spinning properly. The motor hums but it won’t spin. We found that the motor shaft is sitting too low as it is rubbing on the bottom, disabling the drum from spinning properly. This needs to be raised a little higher (see picture attached). Please let us know if you have experience with this. We need this done ASAP.

Miele dishwasher is not working and showing a F14 error message

I recently moved into a property and the oven does not work. The timer is flashing but the heat does not go on. I am hoping someone can check it and get it working again for me or tell me what requires fixing. Thanks!

I have a haier fridge it’s working fine but the display is not working

Our old Fisher and Paykel fridge beeps when the door is closed (and not pushed in manually) which we think is due to the magnet requiring replacement. Reaching out to see if there is anyone who can help with the magnet/seal?